Справочник Пользователя для CaptionCall LLC CR2

                                                                                                          CR2    AC750 Wireless Dual-Band Router 

 

27

This page is used to configure the parameters for wireless LAN clients which may 

connect to your Access Point. Here you may change wireless encryption settings as well 

as wireless network parameters. 

 

Disable Wireless LAN Interface: Check this box to to disable the router’s wireless 

features; uncheck to enable it.     

Band: Select one mode from the following. The default is 2.4 GHz (B+G+N) mode.   

Mode: Support AP, Client, WDS and AP+WDS mode. 

Network Type: This type is only valid in client mode. 

SSID: SSID (Service Set Identifier) is the unique name of the wireless network.   

Channel Width: Select the channel width from the pull-down list.   

ControlSideband: This relates to the channel number used for your wireless network. An 

upper band represents higher channels and vice versa. 

Channel Number: Indicates the channel setting for the router. 

Broadcast SSID: Select "Enable" to enable the device's SSID to be visible by wireless 

clients. The default is enabled. 

WMM: It will enhance the data transfer performance of multimedia data when they’re 

being transferred over wireless network. 

Data Rate: Sets the maximum wireless data rate that your network will operate on. 

Associated Clients: You can see the MAC Address, MAC address, transmission and 

reception packet counters for each associated wireless client. 

 

These settings are only for more technically advanced users who have a sufficient 

knowledge about wireless LAN. These settings should not be changed unless you know 

what effect the changes will have on your Access Point.