Справочник Пользователя для CaptionCall LLC CR2

                                                                                                          CR2    AC750 Wireless Dual-Band Router 

 

6

LAN (1,2,3,4): These four LAN ports are where you will connect networked devices, such 

as PCs, print servers, remote hard drives, and anything else you want to put on your 

network. If you connect this product with the Hub (or Switchboard) correctly, the router’s 

corresponding LED and the Hub’s (or the Switchboard’s) must be illuminates. 

WAN:  10/100Mbps RJ45 port. The WAN port is where you will connect Cable/xDSL 

Modem or other LAN. 

RESET: The Reset Button has two functions, WPS and Factory Default. With the router 

powered on, When selecting the WPS function,use a pin to press and hold the button 

about 2 seconds, the WPS LED will flash two minutes. The other one, use a pin to press 

and hold the button about 5 seconds, the router will restore to factory default. 

POWER: The Power socket is where you will connect the power adapter. Please use the 

power adapter provided with this router. 

Wireless antenna: To receive and transmit the wireless data. 

Before installing the router, make sure your PC is connected to the Internet through the 

broadband service successfully. If there is any problem, please contact your ISP. After 

that, please install the router according to the following steps. Don’t forget to pull out the 

power plug and keep your hands dry. 

 

 

1. Make sure all devices, including your PCs, modem, and router, are powered down.   

2. Using an Ethernet network cable, connect the LAN or Ethernet network port of the 

cable or DSL modem to the router’s WAN port.   

3. Power on the cable or DSL modem, and power on the PC you wish to use to configure 

the router.