Справочник Пользователя для Inkmachines Sweden AB TPS-500
User interface
InkMachines
TPS-500
Rev 3.0 / 2018-05-25
24 (27)
Unpairing a foot switch can be useful if the same foot switch has been paired to 2 or several main units. After
unpairing the unit will no longer respond to that foot switch unless it’s manually paired again.
unpairing the unit will no longer respond to that foot switch unless it’s manually paired again.
To unpair the foot switch, select UNPAIR FOOTSWITCH from the Settings menu.
Active Powerpack
To control and view the correct status/ settings of the Powerpack you want to work with, you need to make
the Powerpack active.
the Powerpack active.
Make Powerpack active;
-
tilt or shake the Powerpack, this will send a signal to the paired Main unit to make the
Powerpack active.
Powerpack active.
-
use the arrow keys on the User interface Control panel to manually select which
Powerpack that should be active. The Active Powerpack will be highlighted on the
display.
Powerpack that should be active. The Active Powerpack will be highlighted on the
display.
Run mode settings for Powerpack and Rotary mode for cable
Kick Start
The Kick start gives extra power to the Tattoo Machine at start up. This could be useful if the machine is
equipped with extra features and the standard voltage is not enough for the start up. There are 4 levels; OFF,
LOW, MEDIUM
equipped with extra features and the standard voltage is not enough for the start up. There are 4 levels; OFF,
LOW, MEDIUM
and HIGH.
When using Neo-Cartridges there is no need to use Kick start.
Note! Only use this feature if necessary, it will increase wear!
Boost mode
The Boost mode will increase your machines power considerable. It will enable the machine to keep the same
speed when the workload is increasing. Depending on your setup this feature can be very useful. There are 4
levels; OFF, LOW, MEDIUM and HIGH.
speed when the workload is increasing. Depending on your setup this feature can be very useful. There are 4
levels; OFF, LOW, MEDIUM and HIGH.
Note! The speed may vary when the machine is started
Note! Only use this feature if necessary, it will increase wear!
Run mode display window for Coil machines
Speed(CPS)
The speed of the machine is displayed as CPS, the cycles per second in Hz.
Duty cycle(DUTY)
The duty cycle is displayed as DUTY in %, it is calculated as the contact time.