Справочник Пользователя для Fibar Group S.A. FGGC001

10

OPERATInG ThE DEVICE

Acoustic and visual indications:
The Swipe is equipped with a buzzer and LED diode, signalling ges-

ture detection, menu position and status of the device.
Validity of every detected gesture or sequence is signalled by:
•  2 short beeps (GREEn) - gesture/sequence is valid
•  Intermittent tone (GREEn) - smooth control using circular 

 

gesture

•  1 long beep (RED) - gesture/sequence is invalid

Reset procedure of the Swipe: 
Reset procedure allows to restore the device back to its factory set-

tings, which means all information about the Z-Wave controller and 

user configuration will be deleted. In order to reset the device:
1.  Make sure the device is powered.
2.  Choose 3rd menu position (3 short beeps).
3.  After few seconds the device will be restarted. not being added 

to the Z-Wave network will be signalized with sequence of 2 short 

beeps, pause, 1 short beep (RED).

Waking up the device: 
The Swipe needs to be woken up to receive information about the 

new configuration from the Z-Wave controller, like parameters and 

associations. use 1st menu position to wake up the device or click the 

button on the back of the device once.

Menu allows to perform Z-Wave network actions. In order to use the 

menu:
1.  Move and hold your hand close to the center of the pad.
2.  Loud sound sequence will confirm entering the menu, keep 

holding your hand.

3.  Wait for the buzzer to indicate the desired menu position:

•   1 short beep (WhITE indicator colour) - wake up the device
•   2 short beeps (GREEn indicator colour) - learning mode  

(adding/removing)

•   3 short beeps (YELLOW indicator colour) - the device reset

4.  To select current position, withdraw the hand and perform swiping 

up gesture to confirm selection (two beeps will confirm validity).

Resetting the device is 

not the recommend-

ed way of removing 

the device from the 

Z-Wave network. use 

the reset procedure 

only if the primary 

controller is missing 

or inoperable. Certain 

device removal can be 

achieved by the pro-

cedure of removing 

described in "Adding 

8.

Gestures are not in-

dicated by the LED 

diode by default. In 

order to enable it, set 

the value of parame-

ter 3 to 1.

If the device is battery 

powered, high pitch 

beep will signalize ex-

iting from the Standby 

Mode before entering 

the menu.

Menu can also be 

operated using the 

service button B (see 

on page 15)