Справочник Пользователя для Fibar Group S.A. FGGC001

14

POWERInG MODES

There are two powering modes of the Swipe. By default, powering 

mode of the device is updated automatically (in intervals specified in 

parameter 5) after changing type of supply. 
The Swipe sends detected gestures to the Z-Wave network 

immediately, but configuration parameters and associations settings 

only at wake up (in time intervals or manually), independently of the 

powering mode.
Battery powering mode - by default, the Swipe is supplied with 

4 batteries included with the device (type AA 1.5V). They are not 

rechargeable and should be replaced after wearing out. The device in 

this mode uses power saving function to preserve battery life.
External supply mode - the Swipe can be supplied with a 5V DC 

power supply connected to the micro-uSB port. In this mode batteries 

will work as an emergency supply.

using batteries other 

than specified may re-

sult in explosion. Dis-

pose of properly, ob-

serving environmental 

protection rules.

Power saving:
When battery powered, the Swipe will enter Standby Mode by default 

(signalled with a low pitch beep) after 5 seconds of inactivity to reduce 

the battery usage. In Standby Mode range and frequency of detection 

are reduced preventing normal gesture detection. Operation of 

power saving mode can be modified in parameter 6.
In order to exit Standby Mode:
1.  Move your hand close to the centre of the pad.
2.  Wait for the high pitch beep.
3.  Move your hand away from the pad.
4.  The device is ready to detect gestures.

The device does not 

work as a Z-Wave  

repeater, even when 

connected to the ex-

ternal power supply.