Справочник Пользователя для Levven Electronics Ltd. GRSUB
GoRave SOULSHAKER
READ & SAVE THESE
Operating Instructions
INSTRUCTIONS
Page 12 of 18
insert into the USB port at the rear of SOULSHAKER. When the standby LED flashes, toggle the
power switch from off and then to on again.
power switch from off and then to on again.
1. Copy the firmware file from your computer to a formatted USB thumb drive.
2. Power on the unit.
3. Insert the USB thumb drive to the USB port.
4. Press and hold the recessed pushbutton above the USB port for 5 seconds until the LED
2. Power on the unit.
3. Insert the USB thumb drive to the USB port.
4. Press and hold the recessed pushbutton above the USB port for 5 seconds until the LED
lights.
5. The upgrade proceeds with the LED lit.
6. Wait until the LED turns off – this means the upgrade is complete.
7. Remove the USB thumb drive from the USB port.
8. Cycle the power. Turn the unit off and on again.
9. Done.
6. Wait until the LED turns off – this means the upgrade is complete.
7. Remove the USB thumb drive from the USB port.
8. Cycle the power. Turn the unit off and on again.
9. Done.
3 T
ROUBLESHOOTING
Mostly the issues in audio systems are result of poor or wrong connections, or improper control
settings. If you encounter problems, isolate the area of difficulty, check the control settings,
determine the cause of the fault and make the necessary changes.
If you are unable to get sound from SOULSHAKER, refer to given suggestions for following
conditions:
settings. If you encounter problems, isolate the area of difficulty, check the control settings,
determine the cause of the fault and make the necessary changes.
If you are unable to get sound from SOULSHAKER, refer to given suggestions for following
conditions:
3.1 S
TANDBY
LED
I
NDICATOR
I
S
N
OT
L
IT
No main power to SOULSHAKER. Check AC power connections at the amplifier and the AC
outlet.
outlet.
3.2 N
O
S
OUND
If the product is getting AC power, but is producing no sound, check the LED indicator on the
side of the amplifier. If SOULSHAKER’s bond LED is dim, it means that SOULSHAKER is seeking
connection, check following conditions,
side of the amplifier. If SOULSHAKER’s bond LED is dim, it means that SOULSHAKER is seeking
connection, check following conditions,
Is SOULSHAKER bonded to a wireless streaming device?
Is the streaming device turned on?
Is audio playing on the wireless streaming device?
Is the streaming device on mute?
Is the volume on the streaming device set too low?
Is audio playing on the wired device?
Is the volume on the wired device set too low?
Note: SOULSHAKER allows only one connection at a given time to play music. If a device is
already bonded with SOULSHAKER and you are trying to play music from another source.
Kindly disconnect the device which is currently bonded with SOULSHAKER before bonding the
desired device with SOULSHAKER to play music.
If the LED is lit solid, it means SOULSHAKER has successfully bonded with a device in green list,
check all of your connections and control settings on associated components.