Справочник Пользователя для Iconnect 96

6 

 

Any Changes or modifications not expressly approved by the party 

responsible for compliance could void the user's authority to operate 

the equipment. 
This device complies with part 15 of the FCC Rules. Operation is 

subject to the following two conditions: (1) This device may not 

cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause 

undesired operation. Note: This equipment has been tested and found 

to comply with the limits for a Class B digital device, pursuant to 

part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with 

the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference 

will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and 

on, the user is 
encouraged to try to correct the interference by one or more of the 

following measures: 
—Reorient or relocate the receiving antenna. 
—Increase the separation between the equipment and receiver. 
—Connect the equipment into an outlet on a circuit different from 

that to which the receiver is connected. 
—Consult the dealer or an experienced radio/TV technician for help. 

 

SAR tests are conducted using standard operating positions accepted 

by the FCC with the device transmitting at its highest certified power 

level in all tested frequency bands, although the SAR is determined 

at the highest certified power level, the actual SAR level of the 

device while operating can be well below the maximum value, in 

general, the closer you are to a wireless base station antenna, the 

lower the power output. 
Before a new device is a available for sale to the public, it must be 

tested and certified to the FCC that it does not exceed the exposure 

limit established by the FCC, Tests for each device are performed in 

positions and locations as required by the FCC. 
For body worn operation, this device has been tested and meets the 

FCC RF exposure guidelines when used with an accessory 

designated for this product or when used with an accessory that 

contains no metal and that positions the device a minimum of 5 

mm from the body. 
Non-compliance with the above restrictions may result in violation of 

RF exposure guidelines.