Справочник Пользователя для Cotton On USA Inc QKS93
Charging method
Insert one end of the power cord to the machine [
] jack, the other end of the USB
insertion USB interface of the computer, or connecting a standard 5V 500mA charging
interface, the charge of "red light", full of "red light".
The machine is built in a charging protection circuit, can be used for a long time to connect a
computer or charger, about 3 hours can be filled with batteries; battery life time will be different
from the use of the volume of time.
Low battery
When the power is low, the system will automatically shut down, at this time,
please charge in time; if you don’t use this machine for long time, at least
charge once a month, which can protect the battery to extend battery life.
please charge in time; if you don’t use this machine for long time, at least
charge once a month, which can protect the battery to extend battery life.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: 1) this device may not cause harmful interference, and 2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
‐‐Reorient or relocate the receiving antenna.
‐‐Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different from that to which the receiver is
‐‐Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different from that to which the receiver is
Connected.
‐‐Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This device is measured RF output power is less than the SAR exclusion threshold value
for human head and body. Therefore, SAR test is not necessary.