Справочник Пользователя для Organix Concept Ltd. AY029

  Wearing the Chest Belt
  Follow steps 1 through 5 to wear the chest belt    
  and go for a run.
1.  Push tab through slot on one side of the chest belt
2.  Press down until the tabs are secure under surface
  and flush so they do not wiggle.
3.  Attach the other side around chest. Position on rib 
  cage under the chest. Make sure the chest belt is   
  positioned in the right direction and worn directly  
  against the skin.
4.  Lift the belt slightly from the skin and wet both    
  grooved areas on the back to ensure strong  

 

  connection between your pulse and the chest    
  belt.
5.  Start the Bluetooth device, and search for the ID 
  of the chest belt. It will automatically connected    
  when it found.

  Battery Installation 
1.  Use a coin to unscrew the battery hatch by 
  turning it counter-clockwise.
2.  Remove old battery and insert a CR2032 3V  

 

  Lithium battery with the writing facing you.
3.  Replace the battery hatch.   

WE STRONGLY RECOMMENDS TAKING YOUR WATCH 
TO A LOCAL RETAILER OR JEWELLER TO HAVE THE 
BATTERY REPLACED TO AVOID THE POSSIBILITY OF 
PERMANENTLY DAMAGING THE WATCH.

  Heart rate doesn’t display on Phone / Device
-  The chest belt may not be positioned correctly. 
-  The grooved sensors may not be wet enough, 
  we and try again. 
-  It is recommended that the grooved sensors are    
  directly on your skin.
  Heart rate reading on Phone / Device is 
  inconsistent or stops
-  The battery may need to be replaced in the Chest  
  Belt.
-  Sources of electromagnetic fields can cause  

 

  interference.  (Appliances, computers, and 
  power lines)  

Avoid extreme force, shock, dust, temperature, or 
humidity. Such conditions may cause malfunction-
ing, a shorter electronic life span, damaged batteries, 
or distorted parts.
Rinse the Chest Belt with fresh water to avoid materi 
als building up that can interfere with the reception 
of the pulse. 

Do not use abrasive or corrosive materials to clean 
the chest belt. Abrasive cleaning agents may scratch 
the plastic parts and corrode the electronic circuit. 

Avoid tampering the internal components of the 
watch. Doing so will terminate the sensors warranty 
and may cause damage. 

FCC no.2ACEG -AY029

This equipment has been tested and found to comply 
with the limits for a Class B digital device, pursuant to part 
15 of the FCC Rules.  These limits are designed to provide 
reasonable protection against harmful interference in 
a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed
 and used in accordance with the instructions, may cause 
harmful interference to radio communications.

However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or  television reception, which can be

encouraged to try to correct the interference by one or more 
of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit di erent 
from that to which the receiver is connected.

This device complies with part 15 of the FCC rules. Operation 
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
 undesired operation.