Справочник Пользователя для RM COSTRUZIONI ELETTRONICHE Snc di Marchioni Davide e Daniele KL7405V
ANT
RX\TX
12V
ANTENNA 50Ω
FREQUENCY RANGE EQUAL
TO OR GREATER OF 28-30MHz
10 METERS BAND
MAXIMUM POWER SUPPOR-
TED BY ANTENNA NOT LESS
THAN 120W
FREQUENCY RANGE EQUAL
TO OR GREATER OF 28-30MHz
10 METERS BAND
MAXIMUM POWER SUPPOR-
TED BY ANTENNA NOT LESS
THAN 120W
PAY ATTENTION TO THE
POWER POLARITY
POWER POLARITY
RADIO
INSTALLATION NOTE
CONNECTION DIAGRAM
This device must be installed in an area where there is adequate ventilation for the heat
sink.
The amplifier is not designed for continuous transmission and should not be operated in
this manner. Failure to observe this will cause the amplifier to shut down from excessive
temperature.
If the amplifier is operated in high ambient temperatures transmission times should be kept
short to avoid excessive heat sink temperature. Excessive heat sink temperature will cause
the amplifier to shut down transmission. This is indicated when the TX LED flashes.
If this occurs operation of the amplifier should be stopped and the amplifier will regain
normal operation when the temperature falls to an acceptable level. This may take more
than 5 minutes.
sink.
The amplifier is not designed for continuous transmission and should not be operated in
this manner. Failure to observe this will cause the amplifier to shut down from excessive
temperature.
If the amplifier is operated in high ambient temperatures transmission times should be kept
short to avoid excessive heat sink temperature. Excessive heat sink temperature will cause
the amplifier to shut down transmission. This is indicated when the TX LED flashes.
If this occurs operation of the amplifier should be stopped and the amplifier will regain
normal operation when the temperature falls to an acceptable level. This may take more
than 5 minutes.
FRONT PANEL
BACK PANEL
[
\
]
^
_
[ Power On Led
\ Transmission state indication LED, if blinking indicates a
overtemperature. To restore turn off and turn on, again, the device.
] Power On switch
^ Modulation type selection (delay return to receive mode)
\ Transmission state indication LED, if blinking indicates a
overtemperature. To restore turn off and turn on, again, the device.
] Power On switch
^ Modulation type selection (delay return to receive mode)
- AM/FM
0
Seconds Delay
- F-SSM
0.8 Seconds Delay
- S.SSB
1.2 Seconds Delay
_ Gain selection
- HI
14db ±1
- MID
12db ±1
- LOW
8db ±1
[ TX/TX 50Ω Connector to be connected to your radio transceive
MAXIMUM POWER-IN 5W
\ ANT 50Ω Connector to be connected to a proper antenna for the
frequency in use
] 13.5V Supply. Lower or unstable voltages compromise device
performance
^ 20A Safety Fuse. Change the value of the fuse is dangerous and
MAXIMUM POWER-IN 5W
\ ANT 50Ω Connector to be connected to a proper antenna for the
frequency in use
] 13.5V Supply. Lower or unstable voltages compromise device
performance
^ 20A Safety Fuse. Change the value of the fuse is dangerous and
[
]
\
^
[
]