Справочник Пользователя для Prentke Romich Company A-ACN100030PRC
Accent 1000 Hardware Manual
14
Removing the Wire Stand
If you do not want to use the stand, you can remove it from the back of the device. You can reattach it
at any time.
1. Place the device face-down on a flat surface.
2. Using a Phillips screwdriver, remove the screws from the holders at the top of each of the stand’s legs.
1. Place the device face-down on a flat surface.
2. Using a Phillips screwdriver, remove the screws from the holders at the top of each of the stand’s legs.
3. Pull the holders free and put the holders and screws in a safe place in case you need to use them
later. Alternatively, you can reinsert the screws in the holes in the device.
Loose holders and screws could be a choking hazard.
4. Spread the legs apart to pull them out of the holes in the back of device.
5. Pull the stand free and put it in a safe place in case you need to use it later.
5. Pull the stand free and put it in a safe place in case you need to use it later.
Important! If you reattach the stand, be sure to secure the legs with the holders to prevent
someone from pulling it loose accidentally.
Removing or Reattaching the Handle
To remove the handle from the device:
1. Using a Phillips screwdriver, remove the two screws that hold the handle in place.
2. Pull the handle away from the device.
3. If you are not going to mount a NuPoint module, it is important to attach the port cover to protect
3. If you are not going to mount a NuPoint module, it is important to attach the port cover to protect
the mini USB connector. See “Attaching or Removing the Port Cover” on page 15.
To reattach the handle:
Remove the port cover or NuPoint module, line up the holes in the handle with the holes on the back of
the device, and insert the two screws.
Screw
Screw holes