Справочник Пользователя для Ulterius Technologies LLC FDN40
CHAPTER 4: RIP
Configuration User Manual
101
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
Invalid after 180 seconds
Flushed after 120 seconds
Send version is 1 2, receive version is 1
Authentication type is none
Split Horizon with poissoned reverse is enabled
Restricts default route installation
Restricts default route origination
4.5.11.4 Configuring Version for Transmitting RIP Advertisement
Refer the Section 4.3 for configuration guidelines and Figure 4-1 for the
Setup. The prerequisite configuration needs to be done in the switches
(FDN40-1 and FDN40-2) before configuring RIP.
1. Execute the following commands to configure version for transmitting RIP
Setup. The prerequisite configuration needs to be done in the switches
(FDN40-1 and FDN40-2) before configuring RIP.
1. Execute the following commands to configure version for transmitting RIP
advertisement.
Enter Global Configuration mode.
UltOs# configure terminal
Enable RIP globally in the switch FDN40-1.
UltOs(config)# router rip
Enable RIP over the interface vlan 1 (IP address 10.0.0.1/16).
UltOs(config-router)# network 10.0.0.1
Exit router configuration mode.
UltOs(config-router)# exit
Enter interface configuration mode.
UltOs(config)# interface vlan 1
Configure version of RIP packets to be sent over the interface vlan 1.
UltOs(config-if)# ip rip send version 1
2. View how FDN40-1 will send (transmit) only RIP version 1 packets over
the interface vlan1 using the following command.
View the RIP send version in interface vlan 1 is 1.
UltOs# show ip protocols
Routing Protocol is rip
RIP2 security level is Maximum
Redistributing : rip
Output Delay is disabled
Retransmission timeout interval is 5 seconds
Number of retransmission retries is 36
Default metric is 3
Auto-Summarisation of routes is Enabled
Routing for Networks :