Справочник Пользователя для Ming Hong Technology Limited 202S

Скачать
Страница из 6
18. FCC  Warning
 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation. 
Changes or modifications not expressly approved by the party responsible for compliance could void the 
user's authority to operate the equipment. 
 
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. 
 
If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the interference 
by one or more of the following measures: 
 
  Reorient or relocate the receiving antenna. 
  Increase the separation between the equipment and receiver. 
  Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
  Consult the dealer or an experienced radio/TV technician for help. 
 
The device has been evaluated to meet general RF exposure requirement. The device can 
be used in portable exposure condition without restriction.   
 
1.  Using the YARDMASTER202Sfor the First Time 
When using the DDOG
®
YARDMASTER202STraining Collar System for the first time, you should make 
sure that the receivercollar has been properly paired with the remote transmitter.     
 
Test for proper pairing 
 
1. 
To test whether the pairing between the two devices has been properly configured, switch on the 
receivercollar by pressing the blue “On/Off” button at the front of the collar.