Справочник Пользователя для Presidio Networked Solutions Inc. AIO3
6
This document contains information and data which is proprietary to Presidio that shall not be duplicated, used, or disclosed - in whole or in part
- for any purpose other than to evaluate this product.
AIO3.0 User’s Manual
PRES058-150422 REV 4
The microcontroller firmware within the AIO3.0 implements the operating modes requested by the
Mapping application and can independently collect, store and transmit data. It monitors and performs
the following functions:
a) The flow of data to and from the wireless modem and GPS receiver
b) Communications to and from the USB serial link,
c) LED status and switch monitoring
d) Power and motion detection monitoring
b) Communications to and from the USB serial link,
c) LED status and switch monitoring
d) Power and motion detection monitoring
Figure 2 – AIO3 Tracking Device
The AIO3 enclosure is a PC/ABS plastic material that provides protection to the subassemblies. The
enclosure includes On/Off and Status push button switches and three status LED’s. The LED’s indicate
the GPS status (navigating no navigating), network status and the on/off state of the device. The device
includes a secondary enclosure that provides an IP68 rated enclosure along with magnets used for
attaching the device to a vehicle.
enclosure includes On/Off and Status push button switches and three status LED’s. The LED’s indicate
the GPS status (navigating no navigating), network status and the on/off state of the device. The device
includes a secondary enclosure that provides an IP68 rated enclosure along with magnets used for
attaching the device to a vehicle.
There is an integrated connector which allows the device to be electrically connected to an
external battery pack or user defined I/O type devices.
external battery pack or user defined I/O type devices.
The AIO3.0 AGenT microcontroller board includes a microprocessor a Telit HE910 wireless modem
along with memory, a 3 axis accelerometer and power management logic.
The Telit wireless module include a GPS receiver that outputs standard NMEA 0183 messages and
operates at L1 (1575.42 MHz) frequency. The battery back-up for the almanac retention is supplied
by the on board power management design. Both the GPS and the wireless modem can be power
managed to turn on/off independent of each other for maximum battery life.
I/O & Supplemental Battery Connector
Power Button
ON/OFF LED
NETWORK LED
GPS LED
Status Button