Справочник Пользователя для Omnitracs LLC IVG2
80-JE026-1 Rev. J
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
27
2. Connect the AUX_IN/DIGIN_2 wire to the ignition source and add a fused connector
(not supplied). A 3amp fuse should be used.
3. Contact Omnitracs Support at 800-541-7490 and request that CDEF444, auto ignition
sense, be disabled.
PTO (Power Take-off)
This option lets you identify and segregate the time the vehicle engine is used for operational
idle purposes, such as when it is powering auxiliary devices using a pump or compressor.
idle purposes, such as when it is powering auxiliary devices using a pump or compressor.
To log PTO time, you must connect the loose white/black wire labeled PTO/DIGIN_1 in the
power I/O cable. The IVG system detects an active PTO device when it sees 12 volts (active
high) on this PTO/DIGIN_1 wire, non-zero RPMs, and speed < 20 MPH. A PTO switch that goes
active to ground will require a relay for the 12-volt detection.
power I/O cable. The IVG system detects an active PTO device when it sees 12 volts (active
high) on this PTO/DIGIN_1 wire, non-zero RPMs, and speed < 20 MPH. A PTO switch that goes
active to ground will require a relay for the 12-volt detection.