Справочник Пользователя для Sunlight Supply Inc 906602
IMPORTANT PRODUCT INFORMATION READ IMMEDIATELY
KEEP ORIGINAL PACKAGING – ALL RETURNS NEED TO BE IN THE ORIGINAL PACKAGING
IN ORDER TO AVOID PRODUCT DAMAGE DURING SHIPPING. ANY DAMAGE TO PRODUCTS
NOT IN THEIR ORIGINAL PACKAGING WILL NOT BE COVERED UNDER WARRANTY.
SAFETY FIRST!
FAILURE TO OBSERVE THE FOLLOWING SAFETY WARNINGS MAY RESULT IN SERIOUS INJURY. IN ADDITION, FAILURE TO OBSERVE THESE
SAFETY WARNINGS WILL RESULT IN A WAIVER OF ALL LIABILITIES ON SUNLIGHT SUPPLY
®
, INC. AND WILL VOID ALL WARRANTIES.
WARNING:
AC/DE FUSION SETUP:
(SUN SYSTEM
®
AC/DE FUSION)
1. Remove the system from the box along with all additional parts.
2. These systems do not require much setup.
3. Carefully install the double ended HPS lamp in the center cavity of the reflector.
A separate instruction sheet detailing DE amp installation is included with this fixture,
please read it carefully before installing the double ended lamp.
4. Attach the Included 20ft power cord to the power receptacle on your unit.
This can be done after hanging the unit if that is easier for you.
5. Hang the fixture using the V-hangers provided (fig.5).
6. Air cooling is required when running this system. Attach 8 inch ducting to your unit
using either hose clamps or zip ties. Specifics will vary from setup to setup but generally
one 8’ inline fan between 660CFM and 750CFM will cool up to 3 units.
7. Set the switch on your unit to the wattage you would like to run your unit on.
This unit can power your DE lamp at 600, 750, 1000, or 1100 Watts.
8. Plug the unit into the proper NEMA configured receptacle.
This fixture must be air cooled while the lamp is powered on. If the unit is not properly air cooled the ballast will dim to 60% power
once the ballast temperature reaches 80ºC (185ºF). If the ballast reaches 90ºC (194ºF) the unit will power off and will not power back
on until the next light cycle.
AC/DE FUSION™ FIXTURE Technical Information Guide
• Disconnect power before re-lamping.
• When re-lamping, make sure lamp has time to cool before touching.
• Make sure power cord is connected properly.
• This unit must be actively air cooled at all times while the lamp is running.
• Do NOT hang by power cord.
• Do NOT make contact with the interior of the socket while the unit is powered.
• Do NOT operate the light systems in wet locations.
• DO NOT plug this system into a supply voltage other than what is instructed
on the ballast.
• DO NOT attempt to open, rewire or reconfigure any components of the light
system. It will void the warranty and could cause serious injury or death.
• These products operate at very high temperatures. Do not place anything on
top of your reflector. Keep away from children.
• Read all warnings and instructions that come with your lamp
FIG. 5
BULB INFORMATION:
PROPER BULB CARE:
Always unplug your ballast and allow your lamp to cool before changing out your lamp. Lamps should be changed out after 20,000 hours to maintain maximum lumen
output. Running a lamp beyond its expected life is not recommended and can cause lamp failure as well as a shift in the color spectrum.