Справочник Пользователя для Tesla Motors Inc 1089773E
Replacing Tires and Wheels
Tires degrade over time due to the effects of
ultraviolet light, extreme temperatures, high
loads, and environmental conditions. It is
loads, and environmental conditions. It is
recommended that tires are replaced every six
years, or sooner if required.
Wheel and tires are matched to suit the
handling characteristics of the vehicle.
Replacement tires must comply with the
original specification. If tires other than those
years, or sooner if required.
Wheel and tires are matched to suit the
handling characteristics of the vehicle.
Replacement tires must comply with the
original specification. If tires other than those
specified are used, ensure that the load and
speed ratings marked on the tire equal or
exceed those of the original specification.
Ideally, you should replace all four tires at the
same time. If this is not possible, replace the
tires in pairs, placing the new tires on the rear.
exceed those of the original specification.
Ideally, you should replace all four tires at the
same time. If this is not possible, replace the
tires in pairs, placing the new tires on the rear.
Always balance the wheel after replacing a
tire.
If you replace a wheel, the TPMS (Tire Pressure
Monitoring System) sensors need to be reset
to ensure they provide accurate warnings
when tires are under- or over-inflated (see
tire.
If you replace a wheel, the TPMS (Tire Pressure
Monitoring System) sensors need to be reset
to ensure they provide accurate warnings
when tires are under- or over-inflated (see
on
page 117).
Warning: For your safety, use only tires
and wheels that match the original
specification. Tires that do not match the
original specification can affect the
specification. Tires that do not match the
original specification can affect the
operation of the TPMS.
Warning: Never exceed the speed rating
of your vehicle's tires. The speed rating is
shown on the sidewall of your tires (see
shown on the sidewall of your tires (see
on page
139).
Asymmetric Tires
Model 3 tires are asymmetric and must be
mounted on the wheel with the correct
Model 3 tires are asymmetric and must be
mounted on the wheel with the correct
sidewall facing outward. The sidewall of the
tire is marked with the word OUTSIDE. When
new tires are installed, make sure that the tires
are correctly mounted on the wheels.
new tires are installed, make sure that the tires
are correctly mounted on the wheels.
Warning: Road holding is seriously
impaired if the tires are incorrectly
impaired if the tires are incorrectly
installed on the wheels.
Removing and Installing Aero Covers
If your Model 3 is equipped with aero covers,
If your Model 3 is equipped with aero covers,
you must remove them to access the lug nuts.
To remove an aero cover, grasp it firmly and
pull it toward you.
To install an aero cover, align it into position so
that the notch is aligned with the tire's valve
stem and then push firmly around its
perimeter until it fully snaps into place.
that the notch is aligned with the tire's valve
stem and then push firmly around its
perimeter until it fully snaps into place.
Tire Care and Maintenance
Maintenance
115
DRAFT
DO
NOT
DISTRIBUTE