Справочник Пользователя для Appareo Systems LLC 000034
Installation Manual
Rev: 1.2
Last Revised: 3/22/16
Document Number: 600840-000038
Page 7 of 11
2
Antenna Hub 1
HCEL-S2-0164A-
00_Rev0 4G CELL-
433MHz-WLAN
00_Rev0 4G CELL-
433MHz-WLAN
1
3
Antenna Hub 2
HIRD-S2-0146A-
0_RevA Iridium-
GNSS-4G
0_RevA Iridium-
GNSS-4G
1
3.4. HARDWARE COMPONENTS BACKGROUND
3.4.1. Electrical Characteristics
Input Power Requirements:
9-16 VDC
Current Draw at 14VDC:
250mA (nominal)
3.4.2. Weight and Balance Information
The total weight of the Gateway and antenna is listed below.
Table 3 Weight and Balance Information
Component
Weight (oz)
Weight (lbs)
Gateway
70.544
4.409
Antenna Hub 1 (HCEL-S2-0164A-01 )
26.624
1.664
Antenna Hub 2 (HIRD-S2-0146A-01)
26.624
1.664
3.4.3. Equipment Dimensions
Equipment dimensions are outlined in the table below for all required components in Gateway.
All figures given are representative of maximum equipment dimensions (where applicable).
All figures given are representative of maximum equipment dimensions (where applicable).
Table 4 Equipment Dimensions
Component
Length
(mm)
Width
(mm)
Height
(mm)
Gateway
165
159
54
Antenna Hub 1 (HCEL-S2-0164A-01 )
124.3
80.3
80.3
Antenna Hub 2 (HIRD-S2-0146A-01)
124.3
80.3
80.3
3.4.4. Conditions for operation
IMPORTANT NOTICE!!!!
This device can be configured to transmit on the 433 MHz frequency following the requirements
of 15.231(a-d). This requirement is that the transmission must be used as a control signal. It
can include data transmission as well, or not, but in all cases it must be a control signal. Failure
to adhere to this requirement
This device can be configured to transmit on the 433 MHz frequency following the requirements
of 15.231(a-d). This requirement is that the transmission must be used as a control signal. It
can include data transmission as well, or not, but in all cases it must be a control signal. Failure
to adhere to this requirement
void’s the authority to operate the equipment.