Справочник Пользователя для Mason Target Systems LLC 100LR01A
Patent Pending
20
Figure 26
4) Remove locknut from carriage bolt of the sensor that you are
replacing
5) Loosen, but do not remove other locknuts. This is to allow
you to adjust the plate while keeping it attached to target
frame
frame
6) Remove old sensor module and insert the new one
7) Secure new sensor module in place with bolt, nut and washer
8) When attaching new sensor module to target, make sure the
7) Secure new sensor module in place with bolt, nut and washer
8) When attaching new sensor module to target, make sure the
components are lined up in the following order*:
a. Carriage Bolt
b. AR500 Plate
c. Rubber Dampener
d. Target Frame
e. Sensor Module
f. Washer
g. Locknut
b. AR500 Plate
c. Rubber Dampener
d. Target Frame
e. Sensor Module
f. Washer
g. Locknut
*Refer to Figure 25 for sensor schematic
9) Torque locknut to 20 ft/lbs. Over tightening carriage bolts will
introduce additional stress and strain in the system
10) Screw cable to corresponding connector on target computer
(refer to Figure 17)
Target Frame