Справочник Пользователя для IDEA ELECTRONICS INC 18IDF10-01

-12-

Always follow these basic safety precautions when using our Digital Photo Frame (DPF). This 

will reduce the risk of fire, electric shock, and injury.

WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or 

moisture. Do not remove the cover. There are no user-serviceable parts inside. Refer all 

servicing to qualified personnel.

• The DPF is for indoor use only.

• Unplug the DPF before performing care and maintenance.

• Do not block the ventilation holes on the back of the DPF at any time.

• Keep your DPF out of direct sunlight and heat sources.

• Route the power cable so that it is not likely to be walked on or pinched by items placed 

   on or against it. Pay particular attention to the point where the cable attaches to the DPF.

• Only use the AC adapter included with the DPF. Using any other power adapter will void 

   warranty.

• Unplug the power cord from the power outlet when the unit is not in use.

Treat the screen gently.

To clean fingerprints or dust from the LCD screen we recommend using a soft, non-abrasive 

cloth such as a camera lens cloth.

If you use a commercial LCD cleaning kit, do not apply the cleaning fluid directly to the LCD 

screen. Clean the LCD screen with the cleaning solution applied to the cleaning cloth.

Clean the outer surface of the DPF with a soft cloth dampened with water.

NOTE: This equipment has been tested and found to comply with the limits for a Class B 

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates, uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one or more of the following 

measures: 

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver 

   is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled 

environment. This device and its antenna must not be co-located or operating in conjunction 

with any other antenna or transmitter. To comply with FCC RF exposure compliance 

requirements, this grant is applicable to only Mobile Configurations. The antennas used for 

this transmitter must be installed to provide a separation distance of at least 20 cm from all 

persons and must not be co-located or operating in conjunction with any other antenna or 

transmitter.