Листовка для Dataram DRL1066RQL/16GB
DRL1066RL
DDR3-1066, PC3L-8500, Registered, ECC, 1.35V, 240-pin DIMMs
DRL1066RL
03-Aug-11
Copyright
2011 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.
Products in Family
DRL1066RQL/16GB (1 x 16GB 4Rx4 DIMM)
Features
Description
240-pin JEDEC-compliant DIMMs
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35 V ±0.075 (1.5 V tolerant)
Fully RoHS Compliant
Thermal Sensor
Heat Spreader
133.35 mm wide by 30 mm high (1.181” x 5.25”)
Data Transfer Rate: 10.6 Gigabytes/sec
Operating Voltage: 1.35 V ±0.075 (1.5 V tolerant)
Fully RoHS Compliant
Thermal Sensor
Heat Spreader
Each DRL1066RL upgrade consists of a single DDR3-
1066 Registered DIMM that conforms to JEDEC’s DDR3,
PC3L-8500 standard. One 2K-bit EEPROM is used for
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
1066 Registered DIMM that conforms to JEDEC’s DDR3,
PC3L-8500 standard. One 2K-bit EEPROM is used for
Serial Presence Detect and a combination register/PLL
with Address and Command Parity is also used. A
thermal sensor accurately monitors the DIMM module
and can prevent exceeding the maximum operating
temperature of 95C.
Dataram Product
Dell Product
Supported in these Dell systems:
DRL1066RQL/16GB
A5180241, A5180244,
A5180152, A5180153,
A5180154, A5180243,
A5180155, A5180156,
A5180157, A5180158,
A5180242, A5185910
A5180152, A5180153,
A5180154, A5180243,
A5180155, A5180156,
A5180157, A5180158,
A5180242, A5185910
Dell PowerEdge C6100, M610, M610X, M710,
M710HD, M915, R410, R510, R715, R810, T410
M710HD, M915, R410, R510, R715, R810, T410
Notes
Tolerances on all dimensions
except where otherwise
indicated are ±.13 (.005).
except where otherwise
indicated are ±.13 (.005).
All dimensions are expressed
in millimeters [inches]
in millimeters [inches]