Справочник Пользователя для Foxconn G41MD
3
33
Advanced Chipset Features
► North Bridge Configuration/ South Bridge Configuration
Press <Enter> to go to its submenu.
North Bridge Configuration
► Memory Remap Feature
This item is used to enable/disable memory remap feature. Its mainly for if you have a 64bit
OS and 4GB of RAM. Basically it allows you to remap the overlapped PCI memory above the
total physical memory.
OS and 4GB of RAM. Basically it allows you to remap the overlapped PCI memory above the
total physical memory.
► DRAM Frequency
This item is used to adjust the DRAM frequency. Select [Auto] for SPD enable mode. You also
can select a value manually such as [800 MHz].
can select a value manually such as [800 MHz].
► Memory Command Rate
This feature allows you to select the delay between the assertion of the Chip Select signal till
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
North Bridge Configuration
North Bridge Chipset Configuration
North Bridge Chipset Configuration
Help Item
Memory Remap Feature
[Enabled]
ENABLE: Allow
PCI MMIO Allocation:4GB To 3328MB
remapping of
DRAM Frequency
[Auto]
overlapped PCI memory
[Auto]
overlapped PCI memory
Memory Command Rate
[Auto]
above the total
Memory Command Rate
[Auto]
above the total
[Auto]
above the total
Memory Timing by SPD
[Enabled]
physical memory.
[Enabled]
physical memory.
Memory Hole
[Disabled]
Initate Graphic Adapter
[PEG/PCI]
DISABLE: Do not allow
[PEG/PCI]
DISABLE: Do not allow
IGD GTT Graphic smemory size [No VT mode, 2MB]
remapping of memory.
DVMT Mode Select
[DVMT Mode]
[DVMT Mode]
PEG Port
[Auto]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Advanced Chipset Features
Advanced Chipset Settings
Help Item
WARNING: Setting wrong values in below sections
Configure North Bridge
may cause system to malfunction.
features.
► North Bridge Configuration
► North Bridge Configuration
[Press Enter]
► South Bridge Configuration
► South Bridge Configuration
[Press Enter]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Press Enter]