Справочник Пользователя для Toshiba W-708

1 8

To add channels

To erase channels

Adding or erasing channels

Adding channels
If a desired channel cannot be scanned
automatically because of a weak signal, it can be
added to the memory.
Erasing channels
You can erase a stored channel from the memory
if it is unnecessary.

1) Follow steps 

 to 

 of “Incoming Antenna/CATV

Signals”.

2) Select “ADD CH” or “ERASE CH” using 

or 

STOP.

3) Enter a channel number of 1 to 125 using

number buttons.
For more than 100 number, first press 

100.

For CATV channels, refer to the chart below.
(For other orders, check with your cable
company.)

4) Repeat steps 2) and 3) to add or erase

channels as necessary.

5) Press 

PROG. to exit.

Selecting stored channels

Once the active channels have been stored, you
can select the channels in two ways below.
Number buttons
To enter digits of the channel number.
• For one-digit number, enter 0 before.
• For more than 100 number, first press 

100.

• Each 

number button needs to be pressed

within 2 seconds.

CH/TRK
To shift up or down the stored channel numbers.

Cable Box/DSS Output Channel
Setting

To set the Cable Box/DSS output Channel on the
VCR.

1) Press 

PROG. to display the MENU screen.

2) Select “PRESET” using 

FF or REW, and press

ENTER.

3) Select “CABLE BOX/DSS” using 

PLAY/X2 or

STOP, and press ENTER.

4) Select “NO”, “C.BOX” or “DSS” using 

FF or REW

according to your connection type.

5) If set to “C.BOX” or “DSS”, select “OUTPUT CH”

using 

PLAY/X2 or STOP. Then enter the output

channel number of your cable box (Usually 3 or
4, check the rear of the cable box.) or line input
mode “L1” using the 

I.SELECT  button according

to your connection.

6) Press 

PROG. to exit.