Справочник Пользователя для Trimble Outdoors SPSX51
G Troubleshooting
166 SPSx51 Modular GPS Receivers User Guide
Receiver issues
This section describes some possible receiver issues, possible causes, and how to solve
them
them
.
Issue
Possible cause
Solution
The receiver does
not turn on.
not turn on.
External power is too
low.
low.
Check the charge on the external battery and, if applicable,
check the fuse.
check the fuse.
Internal power is too
low.
low.
Check the charge on the internal battery.
External power is not
properly connected.
properly connected.
Check that the Lemo connector or 26-pin adaptor is seated
correctly, and that the cable is secured to the receiver.
correctly, and that the cable is secured to the receiver.
Check for broken or bent pins in the connector.
Faulty power cable.
Check that you are using the correct cable for the
port/battery.
port/battery.
Check that the correct battery is connected to a particular
port.
port.
The ports on the GPS receiver are optimized for use with
different types of battery. The 26-pin connector is optimized
for Trimble custom external batteries, and the Lemo port is
optimized for external 12 V batteries such as car, motorcycle,
or truck batteries. If the wrong type of battery is connected
to a port, it is likely that it will cut off earlier than normal.
different types of battery. The 26-pin connector is optimized
for Trimble custom external batteries, and the Lemo port is
optimized for external 12 V batteries such as car, motorcycle,
or truck batteries. If the wrong type of battery is connected
to a port, it is likely that it will cut off earlier than normal.
Check pinouts with a multimeter to ensure internal wiring is
intact.
intact.
Receiver does not
log data.
log data.
Insufficient memory.
Delete old files. Do one of the following:
•
Press
E
for 35 seconds.
•
Use the delete and purge functions in the Data Logging
menu of the web interface.
menu of the web interface.
Data Logging option is
disabled.
disabled.
Order the Data Logging option from your local Trimble
dealer. By default, data logging is disabled on all SPS GPS
receivers. To see if data logging is enabled on your receiver,
check your original purchase order or the receiver
configuration using the web interface.
dealer. By default, data logging is disabled on all SPS GPS
receivers. To see if data logging is enabled on your receiver,
check your original purchase order or the receiver
configuration using the web interface.
The receiver is tracking
fewer than four
satellites.
fewer than four
satellites.
Wait until the receiver display shows that more than four
satellites are being tracked.
satellites are being tracked.
The internal memory
needs to be reformatted
needs to be reformatted
Press
E
for 35 seconds.
The receiver is not
responding.
responding.
Receiver needs a soft
reset.
reset.
Turn off the receiver and then turn it back on again.
Receiver needs a full
reset.
reset.
Press
E
for 35 seconds.