Справочник Пользователя для Metra Electronics 99-4700
APPLICATIONS
GENERAL MOTORS 1982-02
VEHICLES EQUIPPED WITH J-2000 PANEL-STYLE
FACTORY HEAD UNIT PROVISIONS
(SEE INSIDE FOR SPECIFIC APPLICATIONS)
VEHICLES EQUIPPED WITH J-2000 PANEL-STYLE
FACTORY HEAD UNIT PROVISIONS
(SEE INSIDE FOR SPECIFIC APPLICATIONS)
KIT COMPONENTS
TOOLS REQUIRED
Cutting tool
Adjustable wrench
Phillips screwdriver
Spacers
(6) Keps Nuts
(6) Carriage Bolts
KIT FEATURES
Various
mounting depth
alternatives
mounting depth
alternatives
6
7
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Mount the head unit/kit
assembly to the sub-dash with those screws
previously removed.
for proper operation. Mount the head unit/kit
assembly to the sub-dash with those screws
previously removed.
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
B) Twist ends together
C) Solder
D) Tape
2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft
nuts. (see Fig. A)
nuts. (see Fig. A)
DIN HEAD UNITS: Cut and remove the shaft supports from the Extension Housing. Slide
the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the
aftermarket head unit into the cage until secure. (see Fig. B)
the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the
aftermarket head unit into the cage until secure. (see Fig. B)
5
Fig. A
Fig. B
Radio Housing
Extension Housing
3
99-4700
INSTALLATION
INSTRUCTIONS
INSTRUCTIONS
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 200202