Справочник Пользователя для Meco Bonza Series

· Never connect or disconnect LP gas cylinder or fittings

while grill is in use or is hot.

· When the LP gas cylinder is connected, the grill must

be kept outside in a well-ventilated space. Turn off all

of the grill control knobs and the LP cylinder valve

when grill is not in use.

· Move gas hose as far away as possible from hot surfaces.

How to Connect your LP gas cylinder (See STEP 12 of Assembly

Instructions for diagram)

1) Make sure all of the control panel knobs are turned to the

“off” position and verify that the LP gas cylinder valve is

closed by turning the handle on the LP gas cylinder

valve clockwise until it stops.

2) Remove the protective cap from the LP cylinder gas

nozzle.

3) Hold regulator in a straight line with LP cylinder gas

nozzle so the connection does not cross thread.

4) Insert nipple into the LP cylinder nozzle opening.

5) Hand tighten coupling nut in a clockwise direction.

Do not use tools.

6) Perform a Leak Test. (See STEP 13 of Assembly

Instructions for Leak Test Instructions)

How to Disconnect your LP gas cylinder

1) Turn all control knobs to the “off” position and turn the

handle on the LP gas cylinder clockwise until it stops.

2) Turn coupling nut on regulator in a counter-clockwise

direction until regulator is released from threaded LP

cylinder gas nozzle.

3) Place the protective cap over LP cylinder gas nozzle.

BEFORE USING YOUR

LP GAS GRILL

· Do not use an LP gas grill indoors, on recreational

vehicles, or on a boat.

· This LP gas grill is for outdoor use only and should be

placed on firm, level surface. The grill should be setup in

an open area with good ventilation, away from high traffic

areas and combustible materials.

· Combustible or flammable materials should never be

used or stored within 36 inches of the back or sides of

your LP gas grill.

· Locate your LP gas grill at least 10 feet away from your

house or any building. Do not use the grill in a garage,

breezeway, carport, porch, or under a surface that can

catch fire.

· When moving or lifting your Aussie LP gas grill, its

recommended that you grasp the cross supports under

the side tables. Do not lift the grill with only the individual

side table slats.
· When moving your gas grill, you should push the grill in

front of you with the large wheels in the front.

· Carefully read the Important Safeguards

section of this manual (pages 2 thru 4). Make

sure you follow and understand all instructions

and

warnings. If you have any questions

regarding these pages, call 1-800-251-7558 and

· This installation must conform with local codes

or, in the absence of local codes, with either the

National Fuel Gas Code, ANSI Z223.1, or CAN/CGA-

B149.2, Propane Installation Code.

· If an external electrical source is utilized, the

outdoor cooking appliance, when installed, must be

electrically grounded in accordance with local

codes or, in the absence of local codes, with the

National Electrical Codes, ANSI/NFPA 70, or the

Canadian Electrical Code, CSA C22.1.

· If any electric appliance or rotisserie is used with

the LP gas grill, do not allow cords to touch or be near

hot

surfaces. Electric cords should be placed away from

walkways to avoid a tripping hazard.

· Grill storage cover must be removed and placed

at least 36 inches from the LP gas grill while in use.

The grill cover is made of a flammable material. The

grill must be completely cooled before putting the

cover back on the grill.

· Never store a spare or disconnected LP gas

cylinder under or near this LP gas grill.

· Inspect the hose and regulator assembly before

each use. If the hose is cut or damaged or shows

signs of excessive abrasion or wear, do not use the

LP gas grill. Contact the manufacturer, as the hose

must be replaced with an assembly specified by the

manufacturer prior to the further use of the LP

gas grill.

· Use only the hose and regulator assembly that

is supplied with your LP gas grill.

· Use of this LP gas grill other than for the

intended use, or alteration of the LP gas grill in any

way may not be safe and will void any warranty.

· LP gas is not natural gas. The conversion or

attempted use of natural gas in an LP unit is

dangerous and will void your warranty.

· Never use an LP gas cylinder if it shows

signs of: dents, gouges, bulges, fire damage,

corrosion, leak age, excessive rust, or other forms of

visual external damage; it may be hazardous and

should be checked by a Liquefied Petroleum supplier.

Do not use an LP cylinder with a damaged valve.

Selecting a Location

Precautions