Листовка для Beghelli Salvalavista LED 3316

Модели
3316
Скачать
Страница из 2
w w w . b e g h e l l i . c o m
BEGHELLI S.p.A. - Via Mozzeghine 13, 15
40050 MONTEVEGLIO (BO)
Tel. +39 051 9660411
Fax +39 051 9660444
334.900.968
INSTRUCTIONS FOR USE
GB
SalvalavistaLED Beghelli is a specifically calibrated LED electronic device that with his soft lighting emission, prevents visual fatigue and con-
siderably improves TV images.
Positioning: 
- Remove the protective film from the rubber grip (1);
- place the device under or on the rear of the TV set (2);
- connect the device to the mains at 230V and the TV to the electrical outlet placed on the back of 
SalvalavistaLED (3).
Switching on: 
1) automatically: 
SalvalavistaLED automatically switches on and off*** with TV set. 
The device can be switched off by pressing button (4); it will switch automatically on with the TV set.
2) manually: 
SalvalavistaLED manually switches on and off with an on/off button placed on the top (4) independently from the TV set.
Setting of luminous intensity: 
A sustained pressure of button (4) allows to increase or reduce the light intensity. To obtain the desired light intensity a constant pressure on
this button is needed.
***
If the first time of use, the 
SalvalavistaLED does not switch on with TV, the following steps should be followed:
- remove TV plug from 
SalvalavistaLED outlet;
- disconnect 
SalvalavistaLED plug from mains ( 230V);
- connect 
SalvalavistaLED to the mains (230V) by pressing button (4);
- release the button;
- connect the TV set by inserting its plug into 
SalvalavistaLED outlet;
- press 
SalvalavistaLED button for at least 5 seconds until the device switches on;
- press 
SalvalavistaLED button until the device switches off.
TECHNICAL CHARACTERISTICS
Order Code 
3316
Light source (LED)
1W
Electrical input
230V ÷ 0,2/2,5W
CAUTIONARY NOTES / WARRANTY
- This equipment must be used solely for the purpose for which it was built. Any other use is to be considered improper and dangerous.
- For every repairs, contact an authorised service centre and request that original spare parts be used. Failure to do so may compromise
the safety of the equipment.
- If the power cable is damaged, it must be replaced by the Manufacturer or authorised technical assistance supplier.
- The device may not be disposed of as ordinary municipal solid waste. It must be separately collected to avoid damage to the
environment. Under EC Directive 2002/96 and relevant national laws on the disposal of products at the end of their useful life, failure
to comply with the above restriction is punishable by law.
- For information on the terms of the warranty service contact an authorised dealer.