Справочник Пользователя для Cisco TRC5 CTS-RMT-TRC5=
Модели
CTS-RMT-TRC5=
15
Deployment Details
August 2012 Series
15
The QOS settings are copied from the master VCS, so they are
not entered in the non-master.
not entered in the non-master.
Tech Tip
By default, the system log level is set to level 1. This setting configures Cisco
VCS to output high-level (easily readable) events in system log and syslog
messages. The system logs are stored on a Solarwinds server at the IP
address listed below. Administrators can use the information when trouble-
shooting problems with the device.
VCS to output high-level (easily readable) events in system log and syslog
messages. The system logs are stored on a Solarwinds server at the IP
address listed below. Administrators can use the information when trouble-
shooting problems with the device.
Step 5:
Navigate to
System > Logging
, enter the following values, and then
click
Save
:
• Log level—
1
• Address 1—
10.4.48.13
Step 6:
On the master VCS, navigate to
VCS configuration > Clustering
,
enter the following value, and then click
Save
.
• Peer 2 IP address—
10.4.48.131
(non-master)
A cluster communication failure alarm is raised on the master
and on other non–master peers already in the cluster advising
that this new VCS peer is not communicating. This alarm will be
cleared later.
and on other non–master peers already in the cluster advising
that this new VCS peer is not communicating. This alarm will be
cleared later.
Cluster configuration replication is suspended at this point until
the new VCS peer is added. Any changes made to the configura-
tion of the cluster will not be replicated until this VCS has been
added.
the new VCS peer is added. Any changes made to the configura-
tion of the cluster will not be replicated until this VCS has been
added.
Tech Tip
Step 7:
Using PuTTY terminal emulation software, use IP address
10.4.48.131
to log in to the non–master VCS from a PC via SSH Protocol.
Use the following credentials:
• Login as—
admin
• Password—
[password]