Справочник Пользователя для IBM Flex System V7000 Expansion Enclosure 4939H29
Модели
4939H29
8068ch04-Initial Config.fm
Draft Document for Review January 29, 2013 12:52 pm
158
IBM Flex System V7000 Storage Node Introduction and Implementation Guide
Figure 4-6 IBM Flex System V7000 Storage Node first time setup welcome window
6. If you choose to create a new system, it will ask for network information, as shown in
Figure 4-7. Select whether you are using an IPv4 or IPv6 management IP address and
type in the address (you can use either DHCP or static address that was assigned). The
subnet mask and gateway will already have defaults listed, which you can edit.
type in the address (you can use either DHCP or static address that was assigned). The
subnet mask and gateway will already have defaults listed, which you can edit.
Figure 4-7 Create new Storage Cluster
7. Click Finish to set the management IP address for the system. System initialization begins
and might take several minutes to complete.
When system initialization is complete, System Setup is launched automatically. The
setup wizard will take you through the steps to configure basic system settings such as
time and date, system name, and hardware detection and verification.
setup wizard will take you through the steps to configure basic system settings such as
time and date, system name, and hardware detection and verification.
For more details on the rest of the setup wizard steps, please see 4.3, “IBM Flex System
V7000 Storage Node Setup Wizard” on page 161.
V7000 Storage Node Setup Wizard” on page 161.
4.2.2 Using CMM for Initial setup
When the first control enclosure for a new IBM Flex System V7000 is installed in the Flex
System chassis, you must create and configure a system. This procedure is used to guide
you through the necessary steps using the CMM for the first time.
System chassis, you must create and configure a system. This procedure is used to guide
you through the necessary steps using the CMM for the first time.