Справочник Пользователя для ZyXEL 4-port Prestige 792H Router 91-004-342001
Модели
91-004-342001
Prestige 792H G.SHDSL Router
23-2
Internet
Access
Table 23-1 Internet Access Setup
FIELD DESCRIPTION
EXAMPLE
ISP’s Name
Enter the name of your Internet Service Provider. This
information is for identification purposes only.
information is for identification purposes only.
ChangeMe
Encapsulation
Press [
SPACE BAR
] to select the method of encapsulation
used by your ISP. Choices are PPPoE, PPPoA, RFC 1483
or ENET ENCAP.
or ENET ENCAP.
ENET ENCAP
Multiplexing
Press [
SPACE BAR
] to select the method of multiplexing
used by your ISP. Choices are VC-based or LLC-based.
LLC-based
VPI #
Enter the Virtual Path Identifier (VPI) that the telephone
company gives you.
company gives you.
8
VCI #
Enter the Virtual Channel Identifier (VCI) that the telephone
company gives you.
company gives you.
35
ATM QoS Type
Press [SPACE BAR] and select CBR (Continuous Bit Rate) to
specify fixed (always-on) bandwidth. Select UBR (Unspecified
Bit Rate) for applications that are non-time sensitive, such as
e-mail. Select VBR (Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
specify fixed (always-on) bandwidth. Select UBR (Unspecified
Bit Rate) for applications that are non-time sensitive, such as
e-mail. Select VBR (Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
UBR
Peak Cell Rate
(PCR)
This is the maximum rate at which the sender can send cells.
Type the PCR.
Type the PCR.
0
Sustain Cell Rate
(SCR)= 0
Sustained Cell Rate is the mean cell rate of a bursty, on-off
traffic source that can be sent at the peak rate, and a
parameter for burst-type traffic. Type the SCR; it must be less
than the PCR, unless both are set to zero.
traffic source that can be sent at the peak rate, and a
parameter for burst-type traffic. Type the SCR; it must be less
than the PCR, unless both are set to zero.
0
Maximum Burst Size
(MBS)= 0
Refers to the maximum number of cells that can be sent at
the peak rate. Type the MBS. The MBS must be less than
65535.
the peak rate. Type the MBS. The MBS must be less than
65535.
0
My Login
Configure the My Login and My Password fields for PPPoA
and PPPoE encapsulation only. Enter the login name that
your ISP gives you. If you are using PPPoE encapsulation,
then this field must be of the form
and PPPoE encapsulation only. Enter the login name that
your ISP gives you. If you are using PPPoE encapsulation,
then this field must be of the form
user@domain
where
domain identifies your PPPoE service name.
N/A
My Password
Enter the password associated with the login name above.
N/A
ENET ENCAP
Gateway
Gateway
Enter the gateway IP address supplied by your ISP when you
are using ENET ENCAP encapsulation.
are using ENET ENCAP encapsulation.
N/A