Справочник Пользователя для Mitsubishi Electric MSZ-FH35VE-E1

19

1) Check the power supply voltage.
2) Check the indoor/outdoor connecting wire for miswiring.

1) Before servicing the air conditioner, be sure to turn OFF the main unit first with the remote controller, and then after 

confirming the horizontal vane is closed, turn OFF the breaker and/or disconnect the power plug.

2) Be sure to turn OFF the power supply before removing the front panel, the cabinet, the top panel, and the P.C. board.
3) When removing the P.C. board, hold the edge of the board with care NOT to apply stress on the components.
4) When connecting or disconnecting the connectors, hold the housing of the connector. DO NOT pull the lead wires.

1) First, check if the OPERATION INDICATOR lamp on the indoor unit is flashing ON and OFF to indicate an abnormality.
  To make sure, check how many times the OPERATION INDICATOR lamp is flashing ON and OFF before starting serv-

ice work.

2) Before servicing, check that the connector and terminal are connected properly.
3) When the electronic control P.C. board seems to be defective, check the copper foil pattern for disconnection and the 

components for bursting and discoloration.

4) When troubleshooting, Refer to 10-2, 10-3 and 10-4.

Weak batteries may cause the remote controller malfunction.
In this case, replace the batteries to operate the remote controller normally.

<Incorrect>

<Correct>

 1. If RESET button is not pressed, the remote controller may not operate correctly.

2. This remote controller has a circuit to automatically reset the microcomputer when batteries are replaced. 
  This function is equipped to prevent the microcomputer from malfunctioning due to the voltage drop caused by the 

battery replacement.

3. Do not use the leaking batteries.

 Press RESET button with a thin instrument, and 

then use the remote controller.

 Remove the front lid and insert batteries.

    Then reattach the front lid.

OBH623