Справочник Пользователя для Tandberg Data SATA DLT-V4 Internal Black 7301709200
Модели
7301709200
Chapter 2 Installing the Tape Drive
Installing the Tabletop SCSI Tape Drive
DLT-V4 Product Manual
8
• Avoid locations near generators, electric motors, audio speakers, or
other sources of magnetic fields. Magnetic fields can adversely affect
the tape drive and data cartridges.
Setting the SCSI ID
2
All SCSI devices attached to the server or workstation must have a
unique SCSI ID. Check the SCSI IDs on all other devices on the selected
server or workstation, including the SCSI host adapter, and select an
server or workstation, including the SCSI host adapter, and select an
unused SCSI ID for the tape drive. The factory default SCSI ID for this
tape drive is 5, as shown in
. If the tape drive’s factory default
SCSI ID is not already in use by another device on the same SCSI bus, you
do not need to change the SCSI ID.
Figure 1 Rear Panel SCSI
Tabletop Tape Drive
Tabletop Tape Drive
To set the SCSI ID on the tape drive, use a small screwdriver or ballpoint
pen to press the button above the SCSI ID switch to select the next lower
SCSI ID. Press the button below the SCSI ID switch to select the next
higher SCSI ID. Each time you press one of these buttons, the SCSI ID
decreases or increases by one. Press the appropriate button until the
desired SCSI ID appears on the switch display.
Note:
If you attach the tape drive to a narrow (50-pin) SCSI bus, you
can only use IDs 0 through 7.
68-pin high-density SCSI connectors
On
Off
SCSI ID switch
Power cable
connector
connector
Power
switch
switch