Справочник Пользователя для Philips Pocket projector PPX3610 PPX3610/EU
Модели
PPX3610/EU
12
Philips · PPX3610
3 Initial Operation
Setting up the Device
You can position the device so that it lies flat on a table
in front of the projection surface; it is not necessary to
tilt it towards the projection surface. The device com-
pensates for the distortion from the slanted projection
(pincushion distortion).
in front of the projection surface; it is not necessary to
tilt it towards the projection surface. The device com-
pensates for the distortion from the slanted projection
(pincushion distortion).
Connect Power Supply /
Charge Battery
Charge Battery
Mains Voltage at the Site of Installation!
Check whether the mains voltage of the
power supply matches the mains voltage avail-
able at the setup location.
power supply matches the mains voltage avail-
able at the setup location.
1 Insert the small plug of the power supply into the
socket on the rear side of your device.
2 Plug the power supply into the mains.
3 During the charging process, the indicator light on
the side of the device will be red. When the battery
is fully charged, it will turn green.
is fully charged, it will turn green.
4 Charge the built-in battery completely before using
for the first time. This will prolong the life of the bat-
tery.
tery.
VGA
Y-Pb-Pr
HDMI
Pico Station
The battery of the Pico Station will not be
charged while the projector is in use.
charged while the projector is in use.
Charging via Pico Station
The battery of the projector will not be
charged while the projector is in use.
charged while the projector is in use.
Installing or Changing the
Batteries of the Remote
Control
Batteries of the Remote
Control
Risk of Explosion with Incorrect Type of
Batteries
Batteries
Only use the CR 2025 type battery.
There is a risk of explosion if the incor-
rect battery type is used.
rect battery type is used.
1 To access the battery, disengage the locking mecha-
nism (
1) and slide out the battery compartment
(
2).
2 Insert the new batteries into the battery compart-
ment with the positive and negative poles as shown
on the back of the remote control. Make sure the
polarities(+ and -) are aligned correctly.
on the back of the remote control. Make sure the
polarities(+ and -) are aligned correctly.
CAUTION!
Notice
Notice
DANGER!