Справочник Пользователя для Hynix 4GB PC3-12800 HMT351S6CFR8C-PB

1. Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the 

device. This is a stress rating only and functional operation of the device at these or any other conditions above 
those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rat-
ing conditions for extended periods may affect reliability.

2. Storage Temperature is the case surface temperature on the center/top side of the DRAM. For the measurement 

conditions, please refer to JESD51-2 standard.

3. VDD and VDDQ must be within 300mV of each other at all times; and VREF must not be greater than 

0.6XVDDQ,When VDD and VDDQ are less than 500mV; VREF may be equal to or less than 300mV.



1. Operating Temperature TOPER is the case surface temperature on the center / top side of the DRAM. For mea-

surement conditions, please refer to the JEDEC document JESD51-2.

2. The Normal Temperature Range specifies the temperatures where all DRAM specifications will be supported. Dur-

ing operation, the DRAM case temperature must be maintained between 0 - 85

o

C under all operating conditions.

3. Some applications require operation of the DRAM in the Extended Temperature Range between 85

o

C and 95

o

C 

case temperature. Full specifications are guaranteed in this range, but the following additional conditions apply:

a. Refresh commands must be doubled in frequency, therefore reducing the Refresh interval tREFI to 3.9 µs. It 

is also possible to specify a component with 1X refresh (tREFI to 7.8µs) in the Extended Temperature Range. 
Please refer to the DIMM SPD for option availability

b. If Self-Refresh operation is required in the Extended Temperature Range, then it is mandatory to either use 

the Manual Self-Refresh mode with Extended Temperature Range capability (MR2 A6 = 0b and MR2 A7 = 1b) 
or enable the optional Auto Self-Refresh mode (MR2 A6 = 1b and MR2 A7 = 0b). DDR3 SDRAMs support Auto 
Self-Refresh and Extended Temperature Range and please refer to component datasheet and/or the DIMM 
SPD for tREFI requirements in the Extended Temperature Range.

 VDD

Voltage on VDD pin relative to Vss

- 0.4 V ~ 1.8 V

V 

VDDQ 

Voltage on VDDQ pin relative to Vss

- 0.4 V ~ 1.8 V

V 

V

IN

, V

OUT

  Voltage on any pin relative to Vss

- 0.4 V ~ 1.8 V

V 

1

T

STG

 

Storage Temperature 

-55 to +100

o

C

1,  2 

 T

OPER

 Normal Operating Temperature Range

0 to 85

o

C 1,2

 Extended Temperature Range

85 to 95

o

C

1,3