Справочник Пользователя для Akai MAX49 MAX 49

 

 

 
1.

 

To enter Edit Mode, press [EDIT]. 

2.

 

Select a control to edit by touching, pressing, 
or manipulating the desired control (fader, 
pad, etc.). In the LCD, the name of the 
selected control will appear in the upper left 
corner, and the editable parameters will be 
shown below it.  

3.

 

In each page of Edit Mode: 

•  Use the up/down CURSOR BUTTONS 

to move through the parameters on the current page. 

•  If there are multiple pages (indicated by "Pg1," "Pg2," etc.), use the left/right CURSOR BUTTONS 

to move between different pages. 

•  Turn the VALUE DIAL to change the currently selected value/setting. Any value/setting is 

automatically selected; you do not have to press the VALUE DIAL to enter or select it.  

4.

 

To edit more controls, repeat Steps 2-3. 

 
IMPORTANT: To store your new settings in the Program, hold [SHIFT] and press [STORE]. Without storing 
your edited settings, your changes will be lost if you load a new Program. 
 
For an overview of the available parameters, see the EDIT MODE PARAMETERS table at the end of this 
manual. 
 

 
MIDI Channel: This setting determines over which MIDI channel data is sent. The available settings are 
Common, USB A1-A16, and USB B1-B16. 

Octave: The keyboard's octave setting. The available settings are -3 to +3, with 0 as the center octave. 

Transpose: The keyboard's transposition (in half-steps). The available settings are -36 to +36, with 0 as the 
center position (no transposition). 

MIDI to DIN: Determines whether or not MIDI data is sent to the MIDI OUT (On) or not (Off). MIDI data will 
be sent to MAX49's USB connection regardless of this setting.  
 

 
Type:  The type of event that will be sent. The available settings are Note, Program Change, and Program 
Bank. 

MIDI Channel: This setting determines over which MIDI channel data is sent. The available settings are 
Common, USB A1-A16, and USB B1-B16. 

Note: If Note is the selected Type, this assigns the note number. 

Aft: If Note is the selected Type, this determines the Aftertouch settings. The available options are Off, Ch 
(Channel Aftertouch), and Poly (Poly Aftertouch). 

Program Number / Pgm: If Program Change or Program Bank is the selected Type, this determines the 
Program number. The available range is 000 – 127. 

Msb / Lsb: If Program Change or Program Bank is the selected Type, these determine the MSB (Most 
Significant Bit) and LSB (Least Significant Bit). The available range is 000 – 127. 

MIDI to DIN: Determines whether or not MIDI data is sent to the MIDI OUT (On) or not (Off). MIDI data will 
be sent to MAX49's USB connection regardless of this setting.  

Note Mode: If Note is the selected Type, this determines whether it is in Toggle or Momentary Mode.