Справочник Пользователя для Alcatel-Lucent OAW-IAP135
RF Management
• Spectrum analysis remotely scans the 2.4-GHz and 5-GHz
radio bands to identify sources of RF interference. This provides
visibility into non-802.11 RF interference sources and their effect
on 802.11n channel quality.
radio bands to identify sources of RF interference. This provides
visibility into non-802.11 RF interference sources and their effect
on 802.11n channel quality.
Security
• MACSec security for authorization and data encryption
between the AP ports and the wired access layer (requires
MACSec support on the wired edge switch)
MACSec support on the wired edge switch)
• With an OpenDNS service subscription, Alcatel-Lucent Instant delivers
integrated web filtering, malware and botnet protection to every
device connected to the WLAN
device connected to the WLAN
• Integrated Trusted Platform Module (TPM) for secure storage
of credentials and keys
• SecureJack-capable for secure tunneling of wired Ethernet traffic
Operating Modes
• 802.11a/b/g/n Alcatel-Lucent Instant AP
• 802.11a/b/g/n Mobility Controller-managed AP
• Air monitor (AM)
• Secure enterprise mesh
• Remote AP (RAP) when used with a Mobility Controller
• Spectrum analyzer when used with a Mobility Controller
• 802.11a/b/g/n Mobility Controller-managed AP
• Air monitor (AM)
• Secure enterprise mesh
• Remote AP (RAP) when used with a Mobility Controller
• Spectrum analyzer when used with a Mobility Controller
Wireless Radio Specifications
• AP type: Dual-radio, dual-band 802.11n indoor
• Software-configurable dual radio supports 2.4 GHz and 5 GHz
• 3x3 MIMO 802.11n with two spatial streams and up to
• Software-configurable dual radio supports 2.4 GHz and 5 GHz
• 3x3 MIMO 802.11n with two spatial streams and up to
450 Mbps per radio
• Supported frequency bands (country-specific restrictions apply):
-
-
2.400 to 2.4835 GHz
- 5.150 to 5.250 GHz
- 5.250 to 5.350 GHz
- 5.470 to 5.725 GHz
- 5.725 to 5.875 GHz
- 5.250 to 5.350 GHz
- 5.470 to 5.725 GHz
- 5.725 to 5.875 GHz
• Available channels: Managed by Virtual Controller or Mobility
Controller, dependent upon configured regulatory domain
• Controller-managed, dependent upon configured regulatory domain
• Dynamic frequency selection (DFS) optimizes the use of
• Dynamic frequency selection (DFS) optimizes the use of
available RF spectrum
• Supported radio technologies:
- 802.11b: Direct-sequence spread-spectrum (DSSS)
- 802.11a/g/n: Orthogonal frequency division multiplexing (OFDM)
- 802.11n: 3x3 MIMO with three spatial streams
- 802.11a/g/n: Orthogonal frequency division multiplexing (OFDM)
- 802.11n: 3x3 MIMO with three spatial streams
• Supported modulation types:
-
-
802.11b: BPSK, QPSK, CCK
- 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM
• Transmit power: Configurable in increments of 0.5 dBm
• Maximum transmit power:
-
• Transmit power: Configurable in increments of 0.5 dBm
• Maximum transmit power:
-
2.4GHz: 23 dBm (limited by local regulatory requirements)
- 5 GHz: 23 dBm (limited by local regulatory requirements)
• Maximum ratio combining (MRC) for improved receiver
performance
• Cyclic Delay Diversity for improved downlink RF performance
• Short guard interval for 20-MHz and 40-MHz channels
• Low-density parity check (LDPC) for high-efficiency error
• Maximum ratio combining (MRC) for improved receiver
performance
• Cyclic Delay Diversity for improved downlink RF performance
• Short guard interval for 20-MHz and 40-MHz channels
• Low-density parity check (LDPC) for high-efficiency error
correction and increased throughput
• Space time blocking code (STBC) for increased range and
improved reception
• Transmit beam-forming (TxBF) for increased reliability in
signal delivery
• Association rates (Mbps):
- 802.11b: 1, 2, 5.5, 11
- 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
- 802.11n: MCS0 – MCS23 (6.5 Mbps – 450 Mbps)
• 802.11n high-throughput (HT) Support: HT 20/40
• 802.11n packet aggregation: A-MPDU, A-MSDU
- 802.11b: 1, 2, 5.5, 11
- 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
- 802.11n: MCS0 – MCS23 (6.5 Mbps – 450 Mbps)
• 802.11n high-throughput (HT) Support: HT 20/40
• 802.11n packet aggregation: A-MPDU, A-MSDU
Power
• 48 volts DC 802.3af power over Ethernet (PoE) or 802.3at PoE+
- Note:
when using 802.3af POE, the second Ethernet port is
disabled. It is enabled when using an 802.3at POE power
source (or direct DC power).
source (or direct DC power).
• 12 volts DC external AC supplied power (adapter sold separately)
• Maximum power consumption: 12.5 watts
• Maximum power consumption: 12.5 watts
Antenna
• AP134 and IAP134: Three RP-SMA connectors for external
dual-band antennas
• AP135 and IAP135: Six integrated downtilt omni-directional
antennas for 3x3 MIMO with maximum antenna gain of 3.5 dBi
in 2.4 GHz and 4.5 dBi in 5 GHz
in 2.4 GHz and 4.5 dBi in 5 GHz
Interfaces
• Network: Two 10/100/1000BASE-T Ethernet (RJ-45),
auto-sensing link speed and MDI/MDX
• Ethernet ports support MACSec encryption and 802.3az EEE
• 48 volts DC 802.3af PoE or 802.3at PoE+ interoperable with
intellisource power sourcing equipment (both ports)
• Other: One RJ-45 console interface
• 48 volts DC 802.3af PoE or 802.3at PoE+ interoperable with
intellisource power sourcing equipment (both ports)
• Other: One RJ-45 console interface
Mounting
• Included with AP:
- Molded mounting tabs for attaching to 15/16” T-bar drop-tile ceiling
- Molded mounting tabs for attaching to 15/16” T-bar drop-tile ceiling
- Kensington security lock point
• Optional mounting kit:
-
OAW-AP130-MNT
:
OmniAccess AP130 Series wall/ceiling mounting kit
.
- OAW-
AP-130-MNTC2: Alcatel-Lucent 130 series AP mount kit contains
two ceiling-grid rail adapters for interlude and silhouette
style rails
- OAW-
AP-130-MNTW2: Alcatel-Lucent 130 series AP mount kit contains
one flat-surface wall/ceiling secure mount cradle.
Mechanical
• Dimensions/weight (unit):
- 170 mm x 170 mm x 45 mm (6.69” x 6.69” x 1.77”)
- .76 kg (1.68 lb)
• Dimensions/weight (shipping):
- 285 mm x 240 mm x 70 mm (11.22” x 9.45” x 2.76”)
- 1.05 kg (2.31 lb)
- 170 mm x 170 mm x 45 mm (6.69” x 6.69” x 1.77”)
- .76 kg (1.68 lb)
• Dimensions/weight (shipping):
- 285 mm x 240 mm x 70 mm (11.22” x 9.45” x 2.76”)
- 1.05 kg (2.31 lb)
Environmental
• Operating:
- Temperature: 0° C to 50° C (+32° F to +122° F)
- Humidity: 5 to 95% non-condensing
• Storage and transportation temperature range:
- Temperature: -40° C to +70° C (-40° F to +15 8° F)
- Temperature: 0° C to 50° C (+32° F to +122° F)
- Humidity: 5 to 95% non-condensing
• Storage and transportation temperature range:
- Temperature: -40° C to +70° C (-40° F to +15 8° F)
Regulatory
• FCC/Industry of Canada
• CE Marked
• R&TTE Directive 1995/5/EC
• Low Voltage Directive 72/23/EEC
• EN 300 328
• EN 301 489
• EN 301 893
• UL/IEC/EN 60950
• EN 60601-1-1, EN60601-1-2
• CE Marked
• R&TTE Directive 1995/5/EC
• Low Voltage Directive 72/23/EEC
• EN 300 328
• EN 301 489
• EN 301 893
• UL/IEC/EN 60950
• EN 60601-1-1, EN60601-1-2
Certifications
• CB Scheme Safety, cTUVus
• UL2043 Plenum rating
• Wi-Fi certified 802.11a/b/g/n
• UL2043 Plenum rating
• Wi-Fi certified 802.11a/b/g/n
Warranty
• Limited lifetime warranty
Minimum AOS version
• 6.1.1.0 on an Alcatel-Lucent Mobility Controller
Alcatel-Lucent OmniAccess 130 Series Access Points
ALCATEL-LUCENT
DATASHEET
2