Справочник Пользователя для Tandberg Data StorageLoader 2U LTO, 1 x 10 LTO-3 052102
Модели
052102
82
P
RODUCT
M
ANUAL
1016988
C
HAPTER
3—C
ONFIGURING
THE
L
IBRARY
4.
4.
4.
4.
Press
until the selection arrow (
) points to Restore Defaults.
5.
5.
5.
5.
Press Select. The following screen appears.
Note:
This action will reset the library, which will re-boot the system.
6.
6.
6.
6.
Press OK to reset the library, or Back to cancel the action.
After approximately five seconds, the library resets itself.
C
HECKING
THE
S
ETUP
After configuring the library, check the setup by performing the exercises
suggested below. While these exercises are not required, it is a good idea to
verify that your software and hardware are properly communicating before
you begin operation.
Import several cartridges into the library, and load and unload cartridges
into the tape drive or tape drives (see
Run a system demo (see
).
If you have not already done so, install the backup application on the host
computer. Instruct the software to load and unload one or more cartridges
in the tape drive(s). This helps determine whether the software and library
are communicating properly.
Library Settings
Operation Mode
Ethernet
Display Settings
Storage Settings
Restore Defaults
Select
Back
Pending Action:
Restore Defaults
Reset Will Occur!
Continue?
OK
Back