Справочник Пользователя для Tandberg Data StorageLoader 2U LTO, 1 x 10 LTO-3 052102

A

PRIL

 2007

E

This appendix defines error messages that may appear on the library’s front 

panel and provides corrective actions.

 

  

This section describes the general error messages that can appear on the 

library’s operator panel and provides corrective actions.

 lists library error messages in alphabetical order. 

If the corrective action in the table:



Instructs you to reset the library or tape drive, go to 

 for instructions.



Does not correct the error, contact Technical Support at 

 or your service provider.

Most library components can be replaced only by Tandberg Data 

Corporation-approved service providers. If you cannot find an obvious cause for 

the problem, contact your service provider. Do not attempt to replace any 

components other than the tape drive(s) or the magazine(s). If you do, you will 

void your warranty.

! ! ! ! 

Some corrective actions advise you to reset or power the library off and back on. 

To avoid disrupting communication between the host computer and other devices 

on the bus, make sure that there is no activity on the bus before you reset or 

power off the library.
If you need to power the library off, first unload the cartridge from the tape 

drive(s), if possible. If you power the library off and back on while a cartridge is in 

a tape drive, the tape drive may have to perform a lengthy format recovery 

process.