Техническая Спецификация для Conrad Energy Rechargeable AA Battery x4 pc(s) NiZn 1.6V 252000
Модели
252000
Conrad Electronic SE · Klaus-Conrad-Str.1 · 92240 Hirschau
14
.Cycle Life
①Discharge to 1.3V at 300mA;
②Charge 120 minutes at 750mA constant
current with a voltage holding at 1.9V;
③Constant voltage holding at 1.9V to
charge 90 minutes until current drops to
50mA;
④Rest for 15 minutes;
⑤Discharge to 1.2V at a constant current
at 1500mA;
⑥Repeat steps from ② to ⑤ until the
capacity drops to 60%.
②Charge 120 minutes at 750mA constant
current with a voltage holding at 1.9V;
③Constant voltage holding at 1.9V to
charge 90 minutes until current drops to
50mA;
④Rest for 15 minutes;
⑤Discharge to 1.2V at a constant current
at 1500mA;
⑥Repeat steps from ② to ⑤ until the
capacity drops to 60%.
The cycles life shall exceed
200 times
。
15
.Leak-proof
test
Standard charge and store for 14 days
under the following storage
conditions
conditions
: 33 ±3 , Relative
humidity: 80%±5%.
No leakage of electrolyte in
liquid form shall be
observed
observed
。
16
.Vibration
test
Store the cell more than 24 hours
after standard charge, following
vibration tests over an amplitude of 4
mm (0.1575 inches) at a frequency of
16.7 Hz(1000 cycles per minute) and
repeated through any axes during
60mins
vibration tests over an amplitude of 4
mm (0.1575 inches) at a frequency of
16.7 Hz(1000 cycles per minute) and
repeated through any axes during
60mins
。
The subsequent fluctuation of
open circuit voltage and
internal impedance shall be
less than 0.02 V and 5 mΩ
respectively, and the surface
of cell has no obvious change.
open circuit voltage and
internal impedance shall be
less than 0.02 V and 5 mΩ
respectively, and the surface
of cell has no obvious change.
17
.Free falling:
(Drop)
Store the cell more than 24 hours
after standard charge, following a
drop test from 450mm (17.717
inches ) on to a hard-wood board in a
vertical axis 3 times .
drop test from 450mm (17.717
inches ) on to a hard-wood board in a
vertical axis 3 times .
The subsequent fluctuation of
open circuit voltage and
internal impedance shall be
less than 0.02 V and 5 mΩ
respectively, and the surface
of cell has no obvious change.
internal impedance shall be
less than 0.02 V and 5 mΩ
respectively, and the surface
of cell has no obvious change.
18
.Safety
testing
to store it for 1 hour after standard
charged, and to make positive and
negative electrode short-circuit with a
wire with the section 0.75mm
negative electrode short-circuit with a
wire with the section 0.75mm
2
min
and shortest length, the short-circuit
time is 1 hour
time is 1 hour
It shall not explode . However,
leakage of electrolyte, external
deformation or outer sleeve
cracking is permitted.
deformation or outer sleeve
cracking is permitted.
。
19. Safety Valve
Start
Performance
(Over dis-
charging)
Performance
(Over dis-
charging)
to be charged with 1500 mA for 5
hours
safety valve can work
normally, no breakage,
leakage, distortion and out
package breakage are allowed
leakage, distortion and out
package breakage are allowed
20. Safty Valve
Start
Performance
Performance
to be charged with 1500 mA for 5
hours
No explosion, but leakage,
distortion and out package