Техническая Спецификация для Fluke Networks NFC-SWABS-1.25MM Cable tester, cable tester NFC-SWABS-1.25MM
Модели
NFC-SWABS-1.25MM
Cleaning Instructions:
After removing one plastic cover, apply a
small spot of solvent to the starting corner of
the cleaning zone.
small spot of solvent to the starting corner of
the cleaning zone.
Holding the connector perpendicularly, swipe
the end-face from the wet spot into a dry zone.
the end-face from the wet spot into a dry zone.
After pulling a clean wipe from the cube,
apply a small spot of solvent to the starting
edge of the wipe.
apply a small spot of solvent to the starting
edge of the wipe.
Holding the connector perpendicularly, swipe
the end-face from the wet spot into a dry zone.
the end-face from the wet spot into a dry zone.
After pulling a clean wipe from the cube, apply
a small spot of solvent to the starting edge of
the wipe.
a small spot of solvent to the starting edge of
the wipe.
Touch the swab to the wet spot on the wipe
for 3 seconds to absorb a minimal amount of
solvent. A damp swab works better than a wet
one. Applying solvent from the pen directly to
the swab will likely result in excessive solvent.
for 3 seconds to absorb a minimal amount of
solvent. A damp swab works better than a wet
one. Applying solvent from the pen directly to
the swab will likely result in excessive solvent.
Insert the swab into the port and turn several
times while applying gentle pressure. Follow
the damp swab with a dry one, using the
same procedure to remove any remaining sol-
vent from the end-face and alignment sleeve.
times while applying gentle pressure. Follow
the damp swab with a dry one, using the
same procedure to remove any remaining sol-
vent from the end-face and alignment sleeve.
A. Fiber Optic Cleaning Cards
B. Fiber Optic Cleaning Cube
C. Fiber Optic Solvent Swabs
Fiber Optic Cleaning Kit
NFC-Kit-Case
Ordering Information
Model
Description
NFC-Kit-Case
Fiber Optic Cleaning Kit includes cleaning cube with wipes, ten cards with sealed cleaning zones, solvent pen, 2.5 mm port
cleaning swabs and 1.25 mm port cleaning swabs in a rugged carrying case.
cleaning swabs and 1.25 mm port cleaning swabs in a rugged carrying case.
NFC-Kit-Box
Fiber Optic Cleaning Kit includes cleaning cube with wipes, five cards with sealed cleaning zones, solvent pen and 2.5 mm port
cleaning swabs.
cleaning swabs.
NFC-Cube
Cleaning cube with wipes cleans up to 500 end-faces
NFC-Cards-5pack
5 cards with 12 sealed cleaning zones each – perfect for troubleshooting
NFC-SolventPen
Special solvent dispensed from pen (9g)
NFC-Swabs-1.25mm
LC and MU port cleaning swabs (25 count)
NFC-Swabs-2.5mm
SC, ST, 2.5 mm port cleaning swabs (50 count)
NFC-SWABS-MULTI
MTP/MPO port cleaning swabs (25 count)
NFC-Case
Carrying case for cleaning accessories