Справочник Пользователя для Voltcraft VC-10T FLEXClip-on ammeter adapter 254 mm VC-10T FLEX

   There may be transport protection caps in the safety plugs of the measuring lines. Remove them before 

pushing the plugs into the meter sockets.

Before you can measure anything with the current probe, you have to insert the enclosed batteries. 
The operating display (3) flashes slowly when the batteries (>2.5V) are full. If the operating display flashes quickly or 

not at all, the batteries are flat (<2.5 V) and must be replaced at once.

Proceed as follows to insert and replace the batteries: 
Disconnect the meter from any circuits and switch off the 

device (OFF).
Unlock the battery compartment (4) counter-clockwise with 

a small coin or a wide flat-head screwdriver until the mark 

points at the open lock symbol “Unlocked”.
Pull the battery compartment cover from the meter.
Insert two new batteries of the same type in the battery 

compartment in the proper polarity. Observe the polarity 

indications on the battery compartment cover (+ and -).
Close the battery compartment again carefully and lock it in 

the reverse direction. 

   You can order suitable alkaline batteries stating the following order no.: Item no. 65 23 03 (please order two). 

Use alkaline batteries since they offer high performance.