Техническая Спецификация для Lecroy WS104MXs-B 4-channel oscilloscope, Digital Storage oscilloscope, WS104MXs-B
Модели
WS104MXs-B
LeCroy Corporation
WaveAce Integration with Wavestation
page
|
3 of 6
Transfers from WaveAce to WaveStation
Getting signals from WaveStation into WaveAce is a simple matter of connecting the output of the signal
generator to the input of the oscilloscope via coaxial cable. Transferring signals from WaveAce to WaveStation is
even simpler once the USB connections with the PC are established. The following is a step-by-step procedure
for sending a real-world signal from the WaveAce oscilloscope to the WaveStation arbitrary signal generator. The
procedure assumes correct installation of all necessary software and hardware drivers.
1. Connect both instruments to the PC via USB cables. Turn on both of the instruments.
2. For this demonstration, a WaveAce 2034 oscilloscope and LeCroy’s WaveSource 100 oscilloscope
evaluation signal source were used to generate and acquire a pulsed signal as shown in Figure 3. Of
course, any signal of interest may be acquired. A WaveStation 2052 served as the waveform generator.
Figure 3: A screen capture of the WaveAce oscilloscope shows the acquired signal from
the WaveSource 100 evaluation source
3. On the PC, open National Instruments’ Measurement & Automation Explorer application. The application
will automatically detect the WaveAce as shown in Figure 4. Note that the oscilloscope’s USB port must
be set to USBTMC. This is accomplished in the oscilloscope’s Utility menu.