Техническая Спецификация для Phoenix Contact 2961480 REL-MR-230AC/21-21AU High Current PCB Relay 230 Vac 2 CO, DPDT 2961480
Модели
2961480
Nov 13, 2013 2 / 9
Technical data
Contact side
Min. switching current
1 mA (at 24 V)
Limiting continuous current
50 mA
Interrupting rating (ohmic load) max.
1.2 W (at 24 V DC)
Note
the following values are applicable if a gold layer is destroyed
Maximum switching voltage
250 V AC/DC
Minimum switching voltage
5 V (at 10 mA)
Limiting continuous current
8 A
Maximum inrush current
15 A (300 ms)
Min. switching current
10 mA (At 5 V)
Interrupting rating (ohmic load) max.
190 W (at 24 V DC)
Interrupting rating (ohmic load) max.
85 W (at 48 V DC)
Interrupting rating (ohmic load) max.
60 W (at 60 V DC)
Interrupting rating (ohmic load) max.
44 W (at 110 V DC)
Interrupting rating (ohmic load) max.
60 W (at 220 V DC)
Interrupting rating (ohmic load) max.
2000 VA (for 250 V AC)
Switching capacity in acc. with DIN VDE 0660/IEC 60947
2 A (at 24 V, DC13)
Switching capacity in acc. with DIN VDE 0660/IEC 60947
0.2 A (at 110 V, DC13)
Switching capacity in acc. with DIN VDE 0660/IEC 60947
0.2 A (at 250 V, DC13)
Switching capacity in acc. with DIN VDE 0660/IEC 60947
2 A (at 24 V, AC15)
Switching capacity in acc. with DIN VDE 0660/IEC 60947
2 A (at 120 V, AC15)
Switching capacity in acc. with DIN VDE 0660/IEC 60947
2 A (at 250 V, AC15)
General
Test voltage relay winding/relay contact
5 kV AC (50 Hz, 1 min.)
Test voltage relay contact/relay contact
2.5 kV AC (50 Hz, 1 min.)
Operating mode
100% operating factor
Mechanical service life
1 x 10
7
cycles
Standards/regulations
IEC 60664
Standards/regulations
EN 50178
Standards/regulations
IEC 62103
Rated surge voltage / insulation
Basic insulation
Pollution degree
3
Surge voltage category
III
Mounting position
Any
Assembly instructions
Can be aligned without spacing (> 70 °C ≥ 2.5 mm)
classifications
eCl@ss
eCl@ss 4.0
27371104
eCl@ss 4.1
27371104
eCl@ss 5.0
27371001