Справочник Пользователя для Insys ISDN Terminal Adapter 4.0 11-02-01-02-00.015
Модели
11-02-01-02-00.015
Configuration
17
Version 2.02 – 01.04
National parameters 118 – 126
118 Character-delete
character
119 Delete
line
120
Repeat line - line-display character
123 Parity
handling
126
Generating a line feed
5.2 Remote Configuration Via Configurator
The INSYS ISDN TA to be configured is referred to as ”remote TA” here.
The configuring INSYS ISDN TA is referred to as ”local TA” here.
Please make sure that the remote TA is connected to the ISDN line and powered up.
• Start a terminal emulation program
• Configure at the local TA the B channel protocol X.75 and block size 2048 (ATB10).
• Set up an ISDN connection to the remote TA using the command
The configuring INSYS ISDN TA is referred to as ”local TA” here.
Please make sure that the remote TA is connected to the ISDN line and powered up.
• Start a terminal emulation program
• Configure at the local TA the B channel protocol X.75 and block size 2048 (ATB10).
• Set up an ISDN connection to the remote TA using the command
ATD?<isdnnum>?e?<Return>
. The extension e at the end of the call number es-
tablishes an internal control connection to the remote TA.
The called TA responds with a password query. Please enter the correct password (de-
fault: no password, press Return only).
Now you can remote-configure the remote TA using the TA configurator commands (see
chapter TA+ Configurator Commands).
• Configure the parameter for the remote TA from your terminal program and store
fault: no password, press Return only).
Now you can remote-configure the remote TA using the TA configurator commands (see
chapter TA+ Configurator Commands).
• Configure the parameter for the remote TA from your terminal program and store
them (if wanted).
Note:
The active set of parameters can be displayed with the command
show<RETURN>
show<RETURN>
.
• Terminate the ISDN connection by leaving the configurator program using the com-
mand quit. Before, you should execute a RESET command that the remote TA will be
reset, and terminate the connection to the local TA.
reset, and terminate the connection to the local TA.
• Exit the terminal program. After the next reset the changes in the remote TA will be
active.
5.2.1 Remote Access Control
Using the following commands you can setup a list, which allows only dedicated callers
the access to the remote configuration of the INSYS ISDN TA.
If this list is empty (default) or one entry is set to star (*), any incoming call is allowed.
Every incoming call that does not fit to one of the entries of racctab will be rejected with
the explanation “call rejected”.
the access to the remote configuration of the INSYS ISDN TA.
If this list is empty (default) or one entry is set to star (*), any incoming call is allowed.
Every incoming call that does not fit to one of the entries of racctab will be rejected with
the explanation “call rejected”.