Техническая Спецификация для Conrad Energy NiMH-BatteryAAA-Single cell1.2 V / Solder lug: Yes 206615

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau

Accidental short circuit will bring high temperature elevation to the battery as well as shorten the battery life. Be sure to avoid

prolonged short circuit since the heat can burn attendant skin and even rupture of the battery cell case. Batteries packaged in
bulk containers should not be shaken. Metal covered tables or belts used for assembly of batteries into devices can be the

source of short circuits; apply insulating material to assembly work surface.

This battery is designed for recharging. A loss of voltage and capacity of batteries due to self-discharge during prolonged
storage is unavoidable. Charge battery before use. Observe the specified charge rate since higher rates can cause a rise in

internal gas pressure which may result in damaging heat generation or cell rupture and/or venting.

Store in a cool, dry, and well ventilated area and away from sources of ignition, excessive heat and direct sunlight. Keep

container closed when not in use. Protect from physical damage. Separate from incompatible materials. Put it lightly when
packing and transport, prevent the packing and container from damage.

Warning: Storing unpackaged cells together could result in cell shorting and heat build-up.

The battery cells are encased in a non-reactive container; however, if the container is breached or rupture, avoid contact of
internal battery components with acids, aldehydes, and carbamate compounds.

See Section II.

Use exhaust ventilation to keep airborne concentration below exposure limit.

If TLV of product or any component is exceeded, a NIOSH approved air supply respirator is advised in absence of proper
environmental control.

Wear safety glasses or face shield as appropriate.

Not required under normal use.

Not required under normal use.

Eye bath, safety shower, washing facilities.