Техническая Спецификация для Conrad Energy Battery3.7 V / () Connector system Open cable ends / XH 974356-2100-20C

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau

MAK (German Maximum Workplace Concentration)

1333-86-4 carbon black:

3B

7440-02-0 nickel:

1

Water hazard class 2 (Self-assessment): hazardous for water.

SVHC Candidate List of REACH Regulation Annex XIV Authorisation (18/6/2012): None of the igredients is listed

REACH Regulation Annex XVII Restriction (19/9/2012): Nickel (CAS No.: 7440-02-0)

REACH Regulation Annex XIV Authorisation List (14/2/2012): None of the igredients is listed

A Chemical Safety Assessment has not been carried out.

REACH Annex XVII Restricted-27

27. Nickel CAS No 7440-02-0 EC No 231-111-4 and its compounds

1. Shall not be used:

(a) in any post assemblies which are inserted into pierced ears and other pierced parts of the human body unless the rate of

nickel release from such post as semblies is less than 0,2 μg/cm 2 /week (migration limit);

(b) in articles intended to come into direct and prolonged contact with the skin such as:

- earrings,

- necklaces, bracelets and chains, anklets, finger rings,

- wrist-watch cases, watch straps and tighteners,

- rivet buttons, tighteners, rivets, zippers and metal marks, when these are used in garments,

if the rate of nickel release from the parts of the se articles coming into direct and prolonged contact with the skin is greater

than 0,5 μg/cm 2 / week.

(c) in articles referred to in point (b) where these have a non-nickel coating unless such coating is sufficient to ensure that the

rate of nickel release from those parts of such articles coming into direct and prolonged contact with the skin will not exceed
0,5 μg/cm 2 / week for a period of at least two years of normal use of the article.

2. Articles which are the subject of paragraph 1 shall not be placed on the market unless they conform to the requirements set

out in that paragraph.

3. The standards adopted by the European Committee for Standardisation (CEN) shall be used as the test methods for
demonstrating the conformity of articles to paragraphs 1 and 2.