Справочник Пользователя для ConiuGo 700100107 EasyGuard II 700100107
Модели
700100107
33
Revision 9.0
GSM Alarm & Telemetry systems
Difference between the connections are:
•
Voice connection:
The GSM module calls the target number, so that the sevice technician is
able to get information from the maintanence center of his company.
•
Modem connection:
The module establishes a modem connection to the target number. Then
the current connection is handed over to a deliberately application that is
connected to the serial port of the GSM module. Now this connection can
be used for the prefixed time to communicate with this application.
Basically there are three different baud rates to send the data in the data:
o
2400 Baud
o
4800 Baud
o
9600 Baud
•
Teleprogramming:
With the feature of teleprogramming the user is able to dial into the modul
by a modem connection. By this connection you have direct access to the
settings of the GSM module. The connection is built up by the GSM module
(e.g. triggered by the event of an incoming SMS). The user has to accept
the call by running a terminal software on his PC and sending the command
ATA when the “ring” is coming in.
Please note that you have to save the changes in the con-
figuration of the GSM module and end the programming mode
before you hang up the data connection. If this hint is not fol-
lowed the module might stay in the programming mode and
cannot go back into the running mode! As well important: If the
connection was disturbed or cutted (by fluctuation of the GSM
network) the modem as well will stay in the programming mode
and no remote access is possible.
The “dial time” for all three kinds of connections (voice connection, modem connec-
tion and teleprogramming) has to be entered in seconds. This time will set the time in