Техническая Спецификация для Cep Terminals 04100 GSM Remote Switch Control Module 04100
Модели
04100
10
Pins 5 and 6 of the fifth row of terminals correspond to the the analogue inputs AIN 1 (Input 4) and
AIN2 (Input 5). They share a common ground with the Inputs 1-3 (Pin 4 terminal row three)
The voltage supply is applied on pin 1 (VIN +) and pin 2 (GND) of the fourth row of terminals
(marked in red).
The maximum cross-section of the cables to be screwed into the screw terminals is 0,08 mm² - 1.3
mm² (both single core and multistring).
The (FME-Female) connector ANT is used to connect the GSM antenna.
Please observe the maximum output voltage of the relays and the maximum input voltage of the
inputs! Please refer to chapter 3 Operating Conditions for more information.
inputs! Please refer to chapter 3 Operating Conditions for more information.
LED Signals
The STD35 has several LEDs that indicate the current operating status.
If the module is logged into the GSM network, the yellow GSM LED will flash briefly about once every 2
seconds .
seconds .
The green power LED lights up when the external power supply is applied to the device.
Button:
The button on the board is used for development purposes and can be ignored.
Please observe the maximum output current of the relays and the maximum input voltage of the
inputs! Please refer to chapter 8 operating conditions for more information!
inputs! Please refer to chapter 8 operating conditions for more information!
6
Quick start up
The following section provides step by step instructions to get the STD35 up-and-running without
extensive setup.
extensive setup.
6.1 General preparations
You need an activated SIM card of a GSM network provider. The PIN of this card has to be set to “0000”
(4 times zero). As an alternative, you could use the PIN “2468”. To change the PIN you can use a regular
mobile phone. Please refer to your mobile phone manufacturer’s user manual for instructions on how
to change the PIN.
(4 times zero). As an alternative, you could use the PIN “2468”. To change the PIN you can use a regular
mobile phone. Please refer to your mobile phone manufacturer’s user manual for instructions on how
to change the PIN.
If you use a SIM card with a PIN different from “0000” or “2468” in the STD35, the STD35 will use a
“wrong” PIN. After the second attempt to power up the device your SIM card will be blocked. In this
case you need to use the “Super-PIN” or “PUK” to assign a new PIN to your card. Please look into the
user guide of your mobile phone. There you find how to use the PUK to de-block the SIM card.
“wrong” PIN. After the second attempt to power up the device your SIM card will be blocked. In this
case you need to use the “Super-PIN” or “PUK” to assign a new PIN to your card. Please look into the
user guide of your mobile phone. There you find how to use the PUK to de-block the SIM card.
It is also possible to use a SIM card without a configured PIN
In the following we refer to the “Master Mobile” as the mobile telephone which you want to use to
switch the outputs and to configure the STD35 via calls.
switch the outputs and to configure the STD35 via calls.
The “incognito” or “private call” function of the mobile must be deactivated in order to be able to
administer the STD35. In other words, the Master Mobile has to transmit the mobile phone number
with every call. Please refer to the user guide of your mobile telephone to change this setting.
administer the STD35. In other words, the Master Mobile has to transmit the mobile phone number
with every call. Please refer to the user guide of your mobile telephone to change this setting.
To test the setting you can call a different mobile phone; there your phone number or name should be
displayed.
displayed.