Техническая Спецификация для Texas Instruments FPD- Link LVDS to FPD-Link II Embedded Clock LVDS Converter DS99R421 Evaluation Kit FPDXSDUR-43USB/NOP FPDXSDUR-43USB/NOPB
Модели
FPDXSDUR-43USB/NOPB
National Semiconductor Corporation
Date: 5/12/2008
Page 19 of 39
Page 19 of 39
Typical Connection and Test Equipment
The following is a list of typical test equipment that may be used to generate signals for
the TX inputs:
1) Digital Video Source – for generation of specific display timing such as Digital Video
Processor or Graphics Controller with 18-bit RGB LVDS output.
2) Astro Systems VG-835 - This video generator may be used for video signal sources
for 18-bit RGB LVDS output.
3) Any other signal / video generator that generates the correct input levels as specified
in the datasheet.
4) Optional – Logic Analyzer or Oscilloscope
The following is a list of typical test equipment that may be used to monitor the output
signals from the RX:
1) LCD Display Panel which supports digital RGB (3.3V_LVCMOS) inputs.
2) National Semiconductor DS99R421 LVDS to FPD-Link II translator
3) Optional – Logic Analyzer or Oscilloscope
4) Any SCOPE with a bandwidth of at least 43MHz for TTL and/or 2GHz for looking at
The following is a list of typical test equipment that may be used to monitor the output
signals from the RX:
1) LCD Display Panel which supports digital RGB (3.3V_LVCMOS) inputs.
2) National Semiconductor DS99R421 LVDS to FPD-Link II translator
3) Optional – Logic Analyzer or Oscilloscope
4) Any SCOPE with a bandwidth of at least 43MHz for TTL and/or 2GHz for looking at
the differential signal.
LVDS signals may be easily measured with high impedance / high bandwidth differential
probes such as the TEK P6330 differential probes.