Техническая Спецификация для Microchip Technology MCP1631 Evaluation Board MCP1631RD-DCPC1 MCP1631RD-DCPC1
Модели
MCP1631RD-DCPC1
Installation and Operation
© 2009 Microchip Technology Inc.
DS51798A-page 9
The MCP1631HV Digitally Programmable Current Source Reference Design firmware
may be re-programmed with the charger profile for Li-Ion or NiMH/NiCd battery packs.
Firmware profile pre-proccessor definitions are :
may be re-programmed with the charger profile for Li-Ion or NiMH/NiCd battery packs.
Firmware profile pre-proccessor definitions are :
• #define LION_SUPPORT DISABLED
• #define NIMH_SUPPORT DISABLED
• #define LED_DRIVER_SUPPORT ENABLED
Setting one of the profiles to ENABLED and the other two to DISABLED will select the
ENABLED profile at compile time. The re-compiled code will then perform the functions
required for the selected profile.
ENABLED profile at compile time. The re-compiled code will then perform the functions
required for the selected profile.
Figure 2-2 shows the charge profiles for a single-cell 1000 mAh Li-Ion battery pack.
Figure 2-3 shows the charge profile for a three-cell 600 mAh NiMH battery pack with
Temperature Shutdown disabled. Disabling the Temperature Shutdown is only done
one time in the lab to profile the battery pack and chemistry. The Temperature
Shutdown should always be enabled in production firmware to prevent the battery pack
from overheating during a charge cycle.
Figure 2-3 shows the charge profile for a three-cell 600 mAh NiMH battery pack with
Temperature Shutdown disabled. Disabling the Temperature Shutdown is only done
one time in the lab to profile the battery pack and chemistry. The Temperature
Shutdown should always be enabled in production firmware to prevent the battery pack
from overheating during a charge cycle.
FIGURE 2-2:
Li-Ion Charge Profile for 1000 mAh Cell.
0.0
1.0
2.0
3.0
4.0
5.0
0
50
100
150
200
Time (min)
Vo
lt
s
0.0
0.4
0.8
1.2
1.6
2.0
Amps
V
BAT
I
OUT